AAMP of America iSimple User manual

Owner’s
Manual
Media GateWay
PXAMG
Expand Your Factory Radio
iSimple®
A Division of AAMP of America™
13190 56th Court Clearwater, FL 33760
Ph. 866-788-4237
suppor[email protected]
©2013 AAMP of Florida, Inc.
www.isimplesolutions.com
Honda/Acura
HD Radio
Operation
iSimple Connect
Rev. 02-27-13

Table of Contents
Pages
1. HD Radio Operation 3
2. Troubleshooting 4
3. Warranty 5

1
1. HD Radio Operation
Entering Mode Select Menu
Press the XM or SAT button to enter satellite radio mode. Immediately turn the
rotary TUNE KNOB or press the TUNE UP button to scroll through
available
sources. . Once “HD RADIO” is displayed wait six seconds and the mode will auto
select.
Tune Up
Turn the TUNE KNOB clockwise or press “TUNE ▲” manually tune up.
Seek Up
Press the SEEK> button to seek up to next available station.
Tune Down
Turn the rotary TUNE KNOB counter-clockwise or press “TUNE ▼” to manually tune
down.
Seek Down
Press the <SEEK button to seek down to the next available station.
Changing Bands
Press the XM button to switch betweenAM and FM bands.
Store Presets
Tune to the station you want to store as a preset. Press and hold the preset button on
which you want to store the channel.
Recall Presets
Press the preset button that corresponds with the channel you want to recall.
Changing Display
Press the DISP button to toggle between HD artist and HD title.

2
2. Troubleshooting
Symptom Cause Remedy
Radio shows “DEV
INIT” Connect device is initializing This only occurs the rst time the Connect is powered on. Wait a few
minutes, cycle ignition off and on then
enter SAT Mode.
Connect does not
recognize the HD
Radio tuner as a
source
HD Radio tuner
was not plugged in
during initialization.
Press reset button to clear the memory
and re-initialize the Connect

3
3. Warranty
One Year Limited Warranty
The quality controls used in the manufacture of this product will ensure your
satisfaction.Thiswarrantyappliesonlytotheoriginalpurchaserofthisproductfrom
an authorized iSimple dealer. This warranty covers any supplied or manufactured
partsofthisproductthat,uponinspectionbyiSimpleauthorizedpersonnel,isfound
tohavefailedinnormaluseduetodefectsinmaterialorworkmanship.Thiswarranty
does not apply to installation expenses. Attempting to service or modify this unit,
operating this unit under conditionsotherthantherecommendedvoltage willrenderthis
WARRANTY VOID.
Unless otherwise prescribed by law, iSimple shall not be liable for any personal
injury, property damage and or any incidental or consequential damages of any
kind (including water damage) resulting from malfunctions, defects, misuse,
improper installation or alteration of this product. All parts of this iSimple product
are guaranteed for a period of 1 year as follows:
Within the rst 12 months from date of purchase, subject to the conditions above,
iSimple will repair or replace the product at their discretion, if it is defective in
material or workmanship providing it is returned to an Authorized iSimple Dealer,
with PROOF OF PURCHASE from an authorized iSimple dealer.
Warning:
This equipment may be reset by unintentional electrostatic discharge during op-
eration. Exposure to direct sunlight or extreme heat may cause damage or mal-
function.
FCC Class B Radio Frequency
Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential instal-
lation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harm-
ful interference to radio communications. However, there is no guarantee that in-
terference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television recption, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
1. Reorientate or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from
that of which the receiver is connected.
4. Consult the dealer or an experienced radio / television technical for help.
Notice : The changes or modications not expressly approved by the party respon-
sible for compliance could void the user authority to operate the equipment.

For Best Performanc e Have It
Professionally Installe d.
www.isimplesolutions.com