AAXA Technologies P400+ User manual

aaxa
TECHNOLOGIES
User Guide
P400+ Mini Short Throw
Projector

Caution!
WARNING: Please use this product as instructed. Misuse may cause
injury or death.
DO NOT use while driving
DO NOT expose to water or wet surfaces. Electric shock may occur
DO NOT expose the projected LED image to your eyes or the eyes of others
DO NOT block or restrict airow from ventilation holes as this may cause the
projector to overheat
Keep the projector, battery, or
charger away from any heat sources

Battery warning
This product includes a large array of lithium ion batteries. AAXA Technologies employs
only premium lithium ion batteries, the same type used in high-end Electric Vehicles.
Additionally we pay careful attention to battery design safety. That said Lithium Ion
batteries contain a tremendous amount of energy and must be handled with care!
WARNING: Large battery products contain a tremendous amount of energy.
WARNING: Users must handle this product with care. Battery systems are susceptible to
shock damage, vibration damage, punctures, and overheating.
WARNING: Please respect the internal large lithium ion battery. Please remember it
contains a tremendous amount of energy.

Battery warning
Do not keep the product in direct sunlight or near heat sources.
Do not keep the product inside hot environments such as automobiles
during the summer.
Do not attempt to charge in freezing environments, this will damage
batteries.
If damage is suspected DO NOT CHARGE, DO NOT USE.
Always Charge on safe, no-ammable surfaces, away from ammable
objects.
Do not carelessly throw or drop the product.
SUGGESTIONS

Solar Charging Warning
Warning: Do not expose the projector to direct sunlight!
Caution: When using a solar panel to charge the projector makes sure
the projector is covered and / or not under direct sunlight. Monitor the
projector temperature to ensure it does not overheat.

Table of Contents
Chapter 1: P400+ at a Glance
P400+ Introduction
Remote & KeypadRemote & Keypad
Accessories
Chapter 2: Getting Started
Powering On / O󰀨
Focus Adjustment / Throw Distance
Connecting to Speakers/Headphone
Loading External Content
Chapter 3: Menu Screens
Main Menu
Brightness Menu
*Wi Menu
*Mirroring Menu
Streaming Services Menu
O󰀩ce Menu
Files Menu
Browser Menu
Apps Menu
*FAQ: Slideshow/ Zoom
Connecting to Digital Input
Chapter 4: Settings Menu
Advanced Settings
Language Settings
Display Settings
Keystone & Projection Direction
*Bluetooth Menu
Upgrade/Reset
Chapter 5: Technical Details
Troubleshooting
Specications
Notes
1
2
3
4
5
6
7
11
12
13
14
17
19
21
22
23
24
25
29
31
32
33
34
37
38
40
44
45

P400+ at a Glance
1
Chapter 1
Main Unit
Focus Adjustment
TF Card
Headphone Out
19V D/C Power
Power Button
Standard USB 2.0
Compatible
Navigation Pad
Video In

Remote & Keypad
2
Power On/O󰀨 Select Source
Menu Exit/Back
Direction Pad
Both the keypad and remote can be used to navigate through the menus. The Main Menu
Navigation on the remote functions exactly the same as the directional pad on the P400+ unit.
Main Menu
Navigation
Media Player
Menu Navigation
Volume Up
Volume Down
Remote

Accessories
3
*Under various circumstances, the actual accessories may be dierent from
those shown in the pictures above.
Additional accessories are available for purchase at www.aaxatech.com
Power Adapter
Remote Control
Mini Tripod

Getting Started
4
Chapter 2
1. Connect the power cord to the P400+.
2. Connect the other end of the power cord into the wall power source.
3. Toggle the On / O󰀨 switch on the side of the projector to the “ON” position - the
projector should automatically turn on.
Powering ON the projector
Powering OFF the projector
Standby Mode
1. To transition to “STANDBY” mode, press the power button on the remote control.
2. The optical engine should power o󰀨 and the fan should stop spinning. The projector
is now in “STANDBY” mode and can be turned on using the remote control.
*Note: Standby mode will still consume a small amount of power.
1. To turn o󰀨 the projector, toggle the
“Power Switch” to the “OFF” position.
This will fully turn o󰀨 the projector. The
unit can only charge when it is o󰀨.

Focus Adjusment / Throw Distance
5
• Spin the focus wheel up or down until the image becomes
clear.
Focus Adjustment
DIAGONAL SCREEN SIZE
16:9 Aspect Ratio
Throw Distance
Units: Inches
20
30
40
50
60
70
80
90
100
Diagonal Size
Units: Inches
32
48
64
80
96
112
128
144
160
Throw Distance Chart
Throw Ratio 0.7:1
Projection Angle: 100% O󰀨set
*minimum throw distance: 6 inches

Connecting Speakers / Headphones
*CAUTION:Prolonged use of headphones
at a high volume may impair hearing.
6
To connect a Bluetooth Speaker go to
the Bluetooth submenu found under
the settings menu. Please see page
(37) for more information.
Connect your speakers/headphones
to the projector’s audio port.
Step 1:
Step 2:
Step 3:
Ensure that the projector and/or the
headphones are powered on.
Connecting Bluetooth Speakers:
Place the headphones on and enjoy!

7
Loading External Content
The P400+ can read les directly from
both a TF Card and USB Drive.
Supported le types include:
MP3 / WMA / OGG / WAV
AVI / JPG / GIF/ BMP
(up to 64 GB)
(up to 64 GB)

Loading External Content Cont.
How to insert your TF Card
• Slide in your TF card into the TF card
slot on the side of the P400+ (as shown
in picture).
• Gently slide the TF card until it clicks
into place.
8
(up to 64 GB)

Loading External Content Cont.
How to insert your USB Drive
• Slide your USB Drive into the USB port.
• Gently slide the drive until it cannot go in any further.
9
(up to 64 GB)

Loading External Content Cont.
10
Once your TF Card or USB Drive is inserted into the projector, the TF Card or USB
Drive Storage will be loaded automatically and the content can be found through
the Files icon on the Main Menu ( See Page 21 for File Viewer Submenu). To load
Text documents, select the O󰀩ce icon. ( See Page 19 to learn more)

Menu Screens
11
Chapter 3
Main Menu
The P400+ features an Android 9.0 Operating System. This powerful operating system
allows users to (1) Connect to WIFI (2) Stream Content (3) Play Videos/Pictures/Media (4)
Mirror Smartdevices (5) View and Edit MS O󰀩ce and PDF les (6) Browse internet (7) Load
Apps
• Press the left and right directional buttons to choose an icon from the main menu.
• To select a menu option, press the “OK” button in the middle of the navigation pad.
• To go back to the previous screen, press the “Back” button.
• To Jump back to the submenu, press the “Menu” button once.
• To return to the main menu, press the “Return” button twice.
Menu Exit/Back

Brightness Menu
To change the brightness on your P400+:
• Select the “Settings” icon (Fig. 3.1) in the Main Menu then choose
“Brightness” (Fig. 3.2)
• Select the brightness you wish (Fig. 3.3):
Eco Mode/ Standard Mode/ Boost Mode
12
Fig. 3.1 Fig. 3.2
Fig. 3.3
“Boost mode” should only be used in low temperature, low
altitude environments with adequate clearance of exhaust/
intake vents. A tripod is highly recommended. DO NOT
block vents while operating in Boost mode.

Wi Menu (How to connect to Wi)
13
How To Screen Mirror Smartphone:
• In the Main Menu, choose the “Wi Setup” icon (Fig 3.4)
• In the Wi Menu, toggle the Wi icon to “On” and select the Wi network you
desire. Enter password and connect. (Fig 3.5)
• If you enter the password incorrectly, select “forget” the available network to
start over.
Fig. 3.4 Fig. 3.5

14
Mirroring Menu
How To Screen Mirror Smartphone:
• The P400+ allows screen mirroring of Android and Apple IOS smart devices.
Android mirroring is done through a direct P2P connection whereas Apple IOS
devices requires a router/network host for mirroring.
• After connecting the P400+ to wi, in the Main Menu, choose “Mirroring” icon (Fig 3.6)
• In the Mirroring Menu, choose Android or iOS (Fig 3.7)
• Use built-in AirPlay, AirPinCast, AirPinPCSender to screen mirror from your
iOS devices. Android devices can use Smart Mirror or similar onboard casting
functions.
Fig. 3.6 Fig. 3.7