ABL DLB212 User manual

Strela twin monitor arm
Product code: DLB212
Installation guide
Step one: Clamp installation
Please select the
appropriate mounting
holes according to the
thickness of desk
Suggested desktop
Thickness: 18-35mm
Tighten
Website: www.abl-uk.com
Tel: [phone]
Email: [e-mail]
Instruction sheet

Step two: Installing the arm
Warning
Make sure the screw is tight enough
before handing the monitor
Step three: Attaching VESA plate to monitor
Use the provided washers to secure
screws, if required
Tighten the screws
Tighten
Monitor
Instruction sheet
Website: www.abl-uk.com
Tel: [phone]
Email: [e-mail]

Step four: Attaching VESA plate to arm
Slides on and clips into the junction plate,
make sure it locks into place
Step five: Cable management & monitor adjustment
Adjust the screw with 5x5 Allen key to keep the
monitor in balance
Caution
•The product contains items that could be a choking hazard if swallowed. Keep these items away from young children
•Make sure these instructions are read and completely understood before attempt on installation. If you are unsure of any part of this installation, please contact us on
01933 400 080
•The desk or mounting surface must be capable of supporting the combined weight of the mount and the display, otherwise the structure must be reinforced.
•Please check joint parts every two months and tighten screws where necessary.
This product was designed to be installed on a desk. Before installing, make sure the mount will support the combined load of the equipment and hardware. Never exceed the
maximum load capacity 10KG, or else it may result in product failure or personal injury.
Note: This product is intended for indoor use only. Use of this product outdoors could lead to product failure or personal injury
Website: www.abl-uk.com
Tel: [phone]
Email: [e-mail]
Website: www.abl-uk.com
Tel: [phone]
Email: [e-mail]
Instruction sheet