ABTronic TX User manual

USER MANUAL

PAGE 2 ABTRONIC™TX USER MANUAL
Congratulations on your choice of the ABTRONIC™TX
TENS pain Relief Device .
Please read this manual before rst use.
Read before you use!
ABTRONIC™TX should never be used to mask or relieve
undiagnosed pain. Before treating any symptoms of
pain, it is mandatory to diagnose the cause of pain by
a medical professional.

PAGE 3
What is ABTRONIC™TX ?
ABTRONIC™TX , an innovative One Piece Self-Adhesive
electro pain relieve pad incorporating TENS
technology to target specic pain. Elegantly designed
using ultra-thin and flexible medical grade silicone to
perfectly match the contour of your body.
This complete new approach to relieve pain oers a
safe and eective non-drug treatment alternative for
you.
Your body’s natural warning signs of cramps, acute
pains, migraines, injuries resulting in pain, and chronic
pain can be unsettling and need to be relieved.

PAGE 4 ABTRONIC™TX USER MANUAL
The AbTronicTX TENS pain Relief device passes
electrical currents over the skin. The gel pad is a
conducting medium and is a consumable item,
subject to wear and tear. Please replace the gel pad
if it stops providing sufficient contact, if you start to
get and unpleasant feeling when using the device, or
if the device does not stick to the skin properly any
more. If it is not replace skin irritation may result.
Advanced circuitry conserves energy by providing 10
mins per treatment, up to 100 sessions per battery
life time.

PAGE 5
What is TENS?
TENS, transcutaneous electrical nerve stimulation,
which stimulates nerves through the skin. It is
recognized as a clinically proven, eective, non-
medication method of treating pain from certain
causes. It manages pain by stopping the pain gate
to prevent pain signal transmission to the brain,
and helps to release endorphin to sooth pain by
stimulating nerves. It is free from side-eects when
used properly, and can be used as a simple means
of self-treatment. The method is scientically proven
and a medical approved method. Your GP must check
any symptoms to be treated with TENS and must give
instructions how to perform TENS self-treatment.

PAGE 6 ABTRONIC™TX USER MANUAL
 

ON/HI
Button, increase Intensity
OFF/Low
Button, decrease Intensity
LED Light 2
LED Light 1

PAGE 7
CONTROLS
A self-timer switches the unit o after 10 minutes.
1. ON/HI: Turns the unit on and increases the
output intensity. Press once to increase the output
intensity. The higher the intensity - the larger the
contraction. To adjust to maximum output power
you need to push this button 10 times.
2. OFF/LOW: Each pressing of this button decreases
the intensity by one step down until the unit turns
o.

PAGE 8 ABTRONIC™TX USER MANUAL
The ABTRONIC™TX unit has the following 2
program modulation:
LED 1 LED 2 Description
GREEN GREEN
AbTronicTX controller is now
operating
Both Led light will keep flashing
The flashing speed is proportion to
the output intensity
For the Max. Power output, both LED
will be always light up.
RED Low battery indication
RED RED The pad contact with user body is no
good
OFF OFF Unit switch o

PAGE 9
CYCLE MODE PULSE WIDTH PULS RATE ON-TIME
1Constant 200 70 Hz 120 s
2 Burst 200 70 Hz 120 s

PAGE 10 ABTRONIC™TX USER MANUAL
OPERATION
BATTERY
1. Open the battery door by pushing it in the
direction of the arrow:
2. Insert one piece CR 2032 Lithium battery into the
battery compartment. The positive “+” pole of the
battery should be facing you.

PAGE 11
BASIC USE
1. Attach the Abtronic™TX control unit onto the
silicon pad holder. Insert the controller by
aligning the marking on the controller case with
the holder:

PAGE 12 ABTRONIC™TX USER MANUAL
Insert the control unit aligning it with the shorter
marking on the holder at position (1) and turn it
clockwise until it aligns with the longer marking on
the holder at position (2):



PAGE 13
APPLYING GEL PAD
Do not use damaged, worn or dirty gel pad as this might
result in burns.
Always, stick gel pad to all electrodes while using the
product. Don’t apply the product directly to skin, this may
be painful or cause irritation or burns.
Precautions
1. Take the gel pad out of the bag and peel off one
side of the protective film from the gel pad.

PAGE 14 ABTRONIC™TX USER MANUAL
2. Stick the gel pad onto each of the 2 conductive
areas on the rear side of the stimulation pad.
If there is an air bubbles under the gel pad use a
finger and press the air to the side of the pad to
escape.

PAGE 15
3. After affixing all gel pad properly, peel off the
remaining lm.
Do not peel off the gel pad affixed to the
electrode, until you need to replace them with
new ones!

PAGE 16 ABTRONIC™TX USER MANUAL
4. Gel pad Storage
After use, do NOT remove the gel pad, but
always place protective board back to electrode
after use.

PAGE 17
ABTRONIC™TX USER MANUAL
Removing Gel Pad
1. Only remove the gel pad if you need to replace
them with new ones.
2. Turn off the product before removing the gel
pad. Otherwise this may cause pain or irritation.
3. Peel off the complete gel pad slowly in one
piece.
•Remove any remaining gel on the electrodes.

PAGE 18 ABTRONIC™TX USER MANUAL
ABTRONIC™TX PLACEMENT:
ABTRONIC™TX was design to be used to eectively
target specic pain .
•Back pain
•Joint pain (e.g. knee joint, hip joint, shoulder)
•Neuralgia
•Headache
•Menstrual Pain
•Pain after injuries to musculoskeletal system
•Pain with circulatory problems
•Chronic pain through various causes
Please see the diagram with recommended
placement. However, the ABTRONIC™TX is a
personalized tool and can be adapted to suit the
individual. If the below placement are not eective,
please the unit over the area closest.
AFTER you have placed the unit onto your skin,
switch the control unit on.

PAGE 19
BACKFRONT