Set User Data Transfer Via the Remote Control
Programming Step Remote Control Operation
1. Enter Program Mode
2. Set Transfer Data on the first SR2
For all 1000 users, this will take 3 minutes
* (Master Code) #
96 #
Within 3 minutes the green LED will shine,
after 1 x bleep the LED will turn red to confirm
data transfer
3. Exit Program Mode *
Add User Cards Via the Remote Control
Programming Step Remote Control Operation
1. Enter Program Mode * (Master Code) #
2. Add Card: Using Auto ID number
(Allows the SR2 to assign Card to next
available User ID number)
OR
3. Add Card: Select Specific ID number
(Allows manager to define a specific User ID
to associate the card to)
OR
4. Add Card: by Card Number
OR
5. Add Card: Block Enrolment
(Allows the master card to add up to 998
cards in a single step – this takes 2 minutes)
1 (Present Card) #
Repeat Step 2 for additional user cards
1 (User ID) # (Present Card) #
The user ID is any number from 0-997
1 (Input the 8/10 digit Card number) #
1 (User ID) # (Card Quantity) # (The
first card number) #
Card or fob number MUST be consecutive
6. Exit Program Mode *
Add PIN User – For Administrator for Remote Control
Programming Step Remote Control Operation
1. Enter Program Mode * (Master Code) #
2. Add PIN: Via remote controller 1 (Enter PIN number, 4-6 digits) #
3. Exit Program Mode *
Delete User Cards Via the Remote Control
Programming Step Remote Control Operation
1. Enter Program Mode * (Master Code) #
2. Delete Card: By read card
OR
3. Delete Card: Select Specific ID
OR
4. Delete Card: by Card Number
2 (Present Card) #
Repeat Step 2 for additional user cards before
pressing the #
2 (Enter user ID number) #
The user ID is any number from 1-998
2 (Input the 8/10 digits Card number) #
3. Exit Program Mode *
ACCESS SECURITY PRODUCTS LTD
