AccuBANKER MP20 User manual
www.AccuBANKER.com
Quick Start Guide
MP20
Thermal Receipt Printer
2
MP20 Quick Start Guide
1. Paper Roll Installation
A
1. Open the top cover using the two tabs on the
side. Figure A.
B
2. Load the paper roll as shown in the following
picture (left is correct; right is wrong). Figure
B.
C
3. Pull a piece of the paper out through the
feeder and then close the top cover. Figure C.
D
4. Use the cutter of the printer to tear off the
extra paper. Figure D.
E
*Correct paper roll Installation example. Figure E.
2. Printer Installation
A B C D
A. Cash drawer Jack (optional
connection)
B. Serial port connection to the
device
C. Power Jack
D.
Power Switch
3
3. Control Panel
1. Connect the power adapter to the Power Jack, then attach the Power
cord to the Power adapter.
2. Connect the printer to the device using the Serial cable.
3. Turn the Power Switch ON. The "POWER" light indicator will turn on in
the Control Panel.
4. Tap the "FEED" button in the control panel to ensure the paper roll is
well installed. The paper will release while you tap the "FEED" button.
5. The "PAPER" light indicator will be off while the printer has paper.
When the printer detects the paper roll has run out, the light will turn
on to indicate it is necessary to place a new paper roll.
6. The "ERROR" light indicator appears under the following conditions:
paperless, paper jam, print head overheat, print head error, or other
situations.
4. Self-Test Procedure
1. Make sure the printer and cables are well connected to the electric
outlet.
2. Press the feed key and switch on the printer while still pressing the
key. At the same time, the printer will begin a self-check. Release the
key within five seconds, and the printer will print the self-testing list.
Self-Test report: Self-checking can test if the printer is working properly. If
the test list prints correctly, the printer is functioning (this excludes
problems related to the connected interface to PC); otherwise, it needs
repair. Self-checking could print the software version number, print
density, interface type, English characters, and some other characters by
order.
Paper Jam: When a paper jam happens, turn off the power supply, open
the top cover (wait for the print head to cool off) then remove the
jammed paper. After that, reload the paper roll and close the top cover.
Using the recommended paper roll or one with the same quality would
reduce the risk of paper jam.
4
5. Specifications
Printer Specifications
Paper Roll Specifications
Temperature
32° - 104°F (0° - 40°C)
Humidity 25% - 80%
Printer Type
Thermal Receipt Printer
Paper Width 58mm
Power Source (INPUT)
100 - 240 VAC 60/50 Hz
Power Source (OUTPUT) 8.5VDC / 3.0 A
Power Consumption
25 Watts Max.
Cash Drawer 12VDC / 1.0 A
Noise Level
60dB Max.
Printing Speed 90mm/s
Product Weight
1.80 lb (0.80 kg)
Paper Type Thermal Paper
Paper Width
57.5±0.5mm
Paper Thickness 0.06～0.08mm
Paper Roll Diameter
Φ50mm
Other manuals for MP20
1
Table of contents
Other AccuBANKER Printer manuals
