AccuDual ACD-52300 User manual

ACD-52300
User Guide v1.1

Contents:
Package Contents....................................................................................................................................1
Specification............................................................................................................................................1
Front View...............................................................................................................................................2
Rear View................................................................................................................................................2
Connecting the Equipment .....................................................................................................................3
Installing ACD-52300 to tools: ................................................................................................................3
Setting up your ACD-52300 IP address ...................................................................................................4
Ready to Run ACD-52300........................................................................................................................5

1
Package Contents
ACD-52300 x 1
AC Power adapter x 1
VGA Cable x 1
USB-B to USB-A cable x 1
LAN Cable x 1
Specification
AC power input 100V~240V
Net Weight: 4.2 Kg
Gross Weight: 3.0 Kg
Bare product Dimension: 300 * 260 * 45 mm
Packing Dimension: 388 * 325 * 180 mm
Work temperature: Celsius 5 ~ 45 degrees

2
Front View
Rear View

Power Button

Remote Button

Reset button

VGA IN put

DC Power Connector

USB Port

LAN Port

USB IN put

Video out Connector

3
Connecting the Equipment
Installing ACD-52300 to tools:
Please follow the steps below for installing your ACD-52300 to the SEMI tools
1. Remove the VGA cable from SEMI Tool, then connect to VGA cable of ACD-
52300 and secure the screws.
2. Connect 15-pin D-sub connector from VGA monitor to VGA out connector
and secure screws.
3. Connect the ACD-52300 to the network using the LAN port.
4. 8Connect the ACD-52300 USB in to SEMI Tool
5. Plug in the optical mouse and keyboard to USB port
6. Connect the power adapter to the ACD-52300
7. The equipment is intended only for installation in a telecommunication
Centre, a dedicated computer room or a restricted access area
8. Please do not touch for more than 10 seconds for AC power adapter

4
Setting up your ACD-52300 IP address
Default Login
Name: admin
Password: accudual
After you have successfully calibrate your monitor, now you have to setup a
static IP address so the users can access ACD-52300 through this IP address
and do the RCM (Remote Control Management) operation
p.s. please do make sure you re-connect ACD-52300 to the LAN after the initial
configuration of IP address setting
Here below are the instructions to setup your IP address on the ACD-52300
1. Prepare a PC(notebook) and connect it via an Ethernet cable to ACD-52300
LAN port.
2. Disable the wireless interface of the PC.
3. Open a browser. Enter the URL https://kvm.local, and login page appears.
4. Follow the prompts to change the default password.
5. DHCP is now enabled by default.
6. To change network settings to a static IP address: Choose Device Settings >
Network.
7. Select “Static”then setting your IP address XXX.XXX.XXX.XXX/24 and
Gateway

5
8. Continue your configurations while connected with your PC locally, or use
the ACD-52300 remotely via a supported web browser using the ACD-
52300 IP address.
Note: Make sure you reconnect the ACD-52300 to the LAN after configuring with a PC.
You can get more help of the GUI by clicking the help icon in the top
right corner of the web interface to access more help online.
Ready to Run ACD-52300
You are now ready to operate the ACD-52300 RCM (Remote Control
Management) please just open a browser then enter the setting IP address,
and then login and use it.