ACO SplashLight User manual

www.acobd.com/splashlight
ACO SplashLight
Installation Instructions Note
Under normal conditions of use, a fully charged
module should last approximately three to six
months before needing to be charged again.
For optimum performance, always keep the
SplashLights fully charged to preserve lifespan.
Installing ACO SplashLight
1. Use a lifting key to remove the grate from
the shower channel.
Product Description
ACO SplashLight contains two low-voltage
battery-operated LED units which t directly
into the ACO ShowerDrain Premium channel
grating. These units will illuminate once they
come in contact with water and will come o
approximately two minutes after the shower is
turned o.
Charging ACO SplashLight
The LED unit must be fully charged before
installing for the rst time. Make sure the LED
unit is clean and dry, then insert it into the
charger.
Connect charging cord (USB-C) to wall
adapter (not included). The charging process
can take up to 24 hours to complete. Both
units need to be charged before installation.
Premium
2. Remove the existing Bumper Pins from the
sides of the grate.
Technical Data
LED Units:
Pre-programmed to blue lights but can be altered.
Please see ACO SplashLight Programming
Instructions or visit www.acobd.com/splashlight.
Be sure to exercise extreme caution when
handling electrical devices around water.
!

www.acobd.com/splashlight
ACO. creating
the future of drainage
3. Replace Bumper Pins with new ones
provided with ACO SplashLight.
4. Insert SplashLight unit making sure the
lights are facing toward the center of the
grate and the smooth side facing down,
inside the channel.
6. Place the grating back into the channel
and press down gently until whole unit
becomes ush.
5. Carefully slide the unit into the new
Bumper Pins until it locks.
Maintenance
Before charging the LED units, thouroughly
clean and fully dry the entire surface prior to
inserting them into the charger.
The supplied charger is to be used ONLY with
the ACO SplashLight LED units. Use of this
charger with any other rechargeable batteries
may result in severe damage to the unit.
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
West Sales Oce
825 W. Beechcraft St.
Casa Grande, AZ 85122
Tel: [phone]
Fax: [phone]
North East Sales Oce
9470 Pinecone Dr.
Mentor, OH 44060
Tel: [phone]
Fax: [phone]
South East Sales Oce
4211 Pleasant Rd.
Fort Mill, SC 29708
Tel: [phone]
Fax: [phone]
ACO, Inc.
[email protected]
www.acobd.com
© December 2021 ACO, Inc.
All reasonable care has been taken in compiling the information in this document. All recommendations and suggestions on the use of ACO products are made
without guarantee since the conditions of use are beyond the control of the company. It is the customer's responsibility to ensure that each product is fit for its
intended purpose and that the actual conditions of use are suitable. ACO, Inc. reserves the right to change products and specifications without notice.
Print #SD703