Active Secure CLiK64-T series User manual

1
[Insert Date \ Issue]
CLiK64-T User Instructions
1. Press the button on the key tag transmitter for at least one
second to transmit the signal code. A red indicator light will
flash for the duration of the transmission. Pressing and
holding the button down only transmits one pulse. This
reduces unintentional transmissions and conserves battery
life.
2. Release and press the button for one second again to send
another transmission.
3. If the light on the transmitter does not light up when you
press and hold any button, replace the battery.
CLiK64-T-P1
CLiK64-T-P2
CLiK64-T-P3
CLiK64-T-P4

2
[Insert Date \ Issue]
1. Carefully pry open the case with a flat edge tool or
screwdriver from the key ring corner.
2. Make sure the case is laid flat on the table upside down.
3. Push the coin shaped battery out of its holder and replace
it with a CR2032 battery being careful to place the “+”
positive side on top.
4. DO NOT install the batteries backwards. The device will be
damaged.
5. Snap close the case
6. Test the transmitter and look for the red LED light to flash
when a button is pressed for one second.
CLiK64-T Battery Replacement

3
[Insert Date \ Issue]
CLiK64-T Label Placement
Place label in outlined area

4
[Insert Date \ Issue]
Active Control Technology Inc.
3200 Ridgeway Drive, Unit 17
Mississauga, Ontario,
Canada, L5L 5Y6
905-670 5500
www.activecontrol.com
WARNING
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Copyright © 2014
Changes or modifications not expressly approved by Active
Control Technology Inc. could void the user’s warranty and
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation