Actron Compression Tester CP7821 User manual

INSTRUCTIONS
Before making this test it
is a good practice to check
and be sure that all
cylinder head bolts are
tightened to the engine
manufacturer's torque
specifications.
1. Run the engine for about 15
minutesuntilitreachesnormal
operating temperature.
2. With the engine off, loosen all
spark plugs about one turn,
thenusean airhoseto blowall
the dirt out of the spark plug
wells. Then remove all of the
sparkplugsandgaskets.Place
them on a clean flat surface in
the order in which they were
removed. This will help to cor-
relate any compression prob-
lem with the condition of the
plug from the particular cylin-
der involved.
3. Remove the air filter and block
open the carburetor throttle
plates to maximum. Remove
the high tension lead from the
center of the distributor and
ground it.
CP7821
One Year Warranty
If within one year from the date of pur-
chasethisequipmentfailsduetodefectin
materials or workmanship, return it to
Actron and Actron will repair it free of
charge.
This warranty gives you specific legal
rights,andyoumayalsohaveotherrights
which may vary from state to state.
Customer Service
For product information or customer ser-
vicepleasecall1-800-ACTRON-7(1-800-
228-7667) Monday through Friday, be-
tween 8:30 a.m. and 4:30 p.m. Eastern
time or fax anytime at [phone].
Actron can also be reached by Email or
on the Internet.
Email address: [email protected]
Internethomepage: http://www.actron.com
Actron Manufacturing Company
9999 Walford Avenue
Cleveland, Ohio 44102-4696
©1997 Actron Manufacturing Company. Sunpro is a regis-
tered trademark of Snap-On Tools Company and is used
under exclusive license.
2-202103
®
®
4. Hold the compression tester in
the spark plug hole and crank
the engine for at least 4 com-
pression strokes or until pres-
sure stops rising on the tester.
5. Record the compression read-
ing and repeat the test on all
remaining cylinders.
COMPRESSION
TESTER
6. On a normal cylinder, the
needleshouldadvanceoneach
stroke until it reaches a peak.
All cylinders should test within
the engine manufacturer's
specifications and readings
shouldnotvarymorethan10%
from cylinder to cylinder.
7. If the needle fails to advance
normallyorifitremainsthesame
for several strokes and then
startstoclimb,thecylinderhasa
sticking valve.
8. If the compression reading is
15 or more pounds above the
manufacturer'sspecification,it
isindicative of carbon build-up
in the cylinder.
9. If a reading on two adjacent
cylindersis20 poundsormore
lowerthan the rest of the cylin-
ders, a defective head gasket
is indicated.
10. If readings are low or un-
even between cylinders, pour
a teaspoon of S.A.E. #30 oil
intoeachcylinderandretest. If
the readings increase consid-
erably,thefaultispoorlyseated
or worn rings. If the readings
remain about the same, the
valves are at fault.
11. When tests are completed,
put the spark plugs back in the
engineandreturnthehighten-
sion lead to the center of the
distributor.Unblockthethrottle
and replace the air filter.
0
0
30
60
90
120 150
210
180
240
270
300
2
4
6
810 1214
16
18
20
kPa x 100
Compression
Tester