Adaptive Solutions Receive-All User manual

www.receive-all.com
Adaptive Solutions, LLC
INSTRUCTIONS
1. MOUNTING ITEM TO ADAPTER
THERE ARE TWO METHO S FOR USING THE CABLE-TIES TO MOUNT THE ITEMS TO THE
A APTERS: LOOPING AROUN (METHOD A) OR OVER THE TOP (METHOD B). LOOPING AROUN
IS EASIEST, AN GOING OVER THE TOP WORKS BEST FOR SMALLER ITEMS. SEE ILLUSTRAITON
FOR ETAILS. ONCE THE ITEM IS IN THE CORRECT POSITION, PULL CABLE-TIES TIGHT AN USE
A SCISSORS TO REMOVE THE EXCESS MATERIAL. TWO OR THREE CABLE-TIES ARE SUFFICIENT
FOR ATTACHING MOST ITEMS. BE SURE THE ITEM OES NOT EXTEN PAST THE REAR OF THE
A APTER, OTHERWISE THE ITEM WILL NOT ATTACH TO THE ARM BRACE.
2. MOUNTING ARM BRACE
PLACE ARM BRACE ON ARM BY LOOSENING VELCRO
STRAPS AN SLI ING ARM THROUGH OPENING OF
LOOP. PLACE FRONT REST IN PALM OF HAN SO THAT
THE FRONT STRAP CAN BE SECURE BEHIN THE
KNUCKLES. TIGHTEN REAR STRAP
AROUN FOREARM. FOREARM CRA LE
CAN BE SQUEEZE TOGETHER FOR
SMALLER ARMS, OR EXPAN E FOR
LARGER ARMS.
*ALWAYS CHECK SKIN FOR REDNESS
NEAR THE STRAPS AND OTHER CONTACT
AREAS. THIS IS ESPECIALLY IMPORTANT
FOR THOSE WITH REDUCED SENSATION.*
METHOD A METHOD B

www.receive-all.com
Adaptive Solutions, LLC
3. MOUNTING ADAPTER TO ARM BRACE
SWING LOCKING BAR OPEN. PLACE HOOK EN
OF A APTER INTO SLOT NEAR THE REAR OF
THE ARM BRACE. ROTATE A APTER SO THE
LOCKING GROOVE PROTRUSION SLI ES INTO
CHANNEL NEAR THE FRONT OF THE ARM
BRACE. SWING LOCKING BAR SO A APTER IS
LOCKE ONTO THE ARM BRACE. TO REMOVE
A APTER SIMPLY SWING OPEN THE LOCKING
BAR AN REVERSE ROTATION OF A APTER.
4. CHANGING DIRECTION OF LOCKING BAR
(ONLY REQUIRED IF YOU WANT THE LOCKING BAR TO
PIVOT FROM THE OTHER SIDE)
USE A 5/64” ALLEN-WRENCH TO REMOVE THE
SET-SCREW THAT CONNECTS THE LOCKING
BAR TO THE ARM BRACE. MOVE THE
LOCKING BAR SO THE HOLE IN EITHER EN
LINES UP WITH THE OTHER PIVOT LOCATION
ON THE ARM BRACE AN INSTALL SET-
SCREW. (SEE ILLUSTRATION)
. INSTALLING FOAM PAD (ONLY REQUIRED FOR SMALLER ARMS OR IF ADDITIONAL COMFORT IS
REQUIRED )
PEEL A HESIVE BACKING FROM FOAM. BEGIN BY ALIGNING FOAM WITH THE BOTTOM
AN REAR-MOST PORTION OF THE ARM BRACE. PREVENT FOAM FROM STICKING TO
THE SI ES OF THE CRA LE. PRESS FOAM ONTO CRA LE BY STARTING FROM THE
CENTER AN WORK TOWAR S THE SI ES. PAY CAREFUL ATTENTION TO PRESSING
THE FOAM INTO THE CORNERS BEFORE PRESSING IT TO THE SI ES. TRIM EXCESS
FOAM AS ESIRE .
LOCKING BAR IN
OPEN POSITION
PIVOT LOCATIONS