commode assembly
instructions and precautions
1. Before assembling seat and lid, allow
toilet seat and lid to reach room
temperature if exposed to cold. This will
help prevent the seat and lid clamps from
cracking while being assembled onto
commode back cross brace.
2. Align the toilet seat clamps onto the back
frame rail. (Both clamps should sit
outside the pail brackets). Push down on
seat until clamps snap firmly into place.
Item # PC 1000 RD
Shown
adjusting leg height
1. Before use, adjust height of each leg to
your specific needs, making sure all legs
are at the same height. When desired
height is reached, lock legs into place by
aligning buttons into proper holes, per
figure 2.
2. To be sure legs are locked into place by
pushing down on or by pulling legs.
WEIGHTCAPACITYLBS
figure 2
additional precautions
1. Toilet seat must be in down position
before use. Failure to do so may result in
breakage of commode and
possible injury.
2. Do NOT install commode without first
reading and understanding this assembly
and instruction sheet. If you can not
understand these instructions, contact a
healthcare, dealer or technical
professional before attempting to install.
Otherwise, injury or damage may occur.
3. Inspect all parts for shipping damage
before assembly. If there is shipping
damage - DO NOT USE. Contact dealer/
carrier for further instructions.
4. Make certain that the height
adjusting snap buttons fully protrude
through the same respective hole of each
leg extension. This will ensure that the
leg extensions are securely locked in
position and an even height is achieved
(see Figure 1).
5. Check the rubber tips on the leg
extensions for rips, wear or if they
are missing. Immediately replace any or
all if any of these imperfections exist.
6. All four leg extensions with rubber tips
MUST touch the floor simultaneously
at all times.
7. Users with limited physical strength
should be supervised or assisted while
using commode.
3. Install commode bucket by dropping into
bucket frame. Reverse to remove.
4. Install legs by depressing push pins on the
legs and slide into the frame. When locked
into position, the push pins will “CLICK”
through the frame.
