AMG 770-405 User manual

Blow molded
Transfer
Bench
770-405
Instruction Manual

Please read carefully before use
• Examine the product for shipping damage. Do not use the
product if there is apparent damage. Please contact your
dealer for repair and / or return information.
• Verify that all screws and bolts are tightly secured.
Assembly instructions
1.Snap the armrest into position, making sure the side
buttons pass through armrest holes.
Fig. 1

2.Determine on which side of the unit you want to install the
backrest. Make sure the unit will be facing the faucets with
the armrest on the inside of the bathtub (See Fig. 1)
3.To install the seat and backrest assembly, place the front
seat z-clamps under the front frame support tube. Lower
the seat back and snap the back seat white clips into place.
4.Adjust the unit to the desired height by pressing in the leg
push-button and sliding the leg upward or downward until
the button snaps into desired hole.
NOTE:
The transfer bench should be level. It is therefore possible
that the legs inside the bathtub may be adjusted to a height
different from the legs outside the bathtub.
5.Place the transfer bench with the suction tips legs over the
bathtub wall. The inner legs should be as close to the far
wall of the tub as possible.
6.Push down gently on the transfer bench to securely affix
the suction tip feet to the tub floor.
7.To remove the unit from the bathtub, always release the
suction tips by first pinching the tabs so as to break the
suction. Failure to do so will make it difficult to lift the
unit.

8.To remove the seat and backrest assembly from the unit,
lift the back portion of the seat while holding the frame
firmly in place. This will disengage the rear seat clips from
the frame tube.
CAUTION:
When lifting the seat off the frame, always pull the metal
tube and not the seat / backrest pads.
User safety instructions
1.Make sure all the push buttons are popped out and fully
engaged in selected holes.
2.Before using the transfer bench, always test for stability by
vigorously attempting to move the unit.
3.Weight limit is 350 lbs (158 kg ).

REV. 2.0 0203
Maintenance
1.We recommend that you regularly verify that all bolts and
screws are properly tightened.
2.Clean the pads with soap and water or mild liquid
householder cleaners. Avoid the use of harsh cleaning
solvents, such as acetone, which may attack the plastic
parts.
3.If a mechanical defect appears, do not attempt to use the
unit. Contact your dealer for repair.