ADC ETP-64 User manual

www.adc.com • [phone] • 1-800-366-3891
Spec Sheet
ETP-64 Ethernet Termination Panel
Central Office Connectivity for Carrier Ethernet Services
The Ethernet termination panel was developed to provide a streamlined transition from the
connectorized interface cables of a carrier Ethernet system to main distribution frame (MDF)
paired circuits.
The panel is relay rack mounted and terminations are made on the rear of the Ethernet panel.
Installing the ADC ETP-64 Ethernet termination panel allows separate circuits to route individually
or grouped as needed by bringing all circuits out to the MDF.
Features
All connections made on rear side of ETP-64•
64ea. 4-wire Ethernet ports from Central Office based equipment via 50 pin AMP (male/plug type)•
connectors
64ea. 4-wire Ethernet ports (128 pair) to MDF via LSA-PLUS NT IDC terminal blocks•
Internal wiring directly connects the equipment side to MDF side (no cross connect jumpering)•
ETP-64 converts from 50 pin AMP type connector to individually paired circuits•
Test access point for wire testing and troubleshooting of equipment independent of MDF wiring•

Website: www.adc.com
FromNorthAmerica,CallTollFree:1-800-366-3891•OutsideofNorthAmerica:[phone]
Fax:[phone]•ForalistingofADC’sglobalsalesofficelocations,pleaserefertoourwebsite.
ADC Telecommunications, Inc., P.O. Box 1101, Minneapolis, Minnesota USA 55440-1101
Specifications published here are current as of the date of publication of this document. Because we are continuously
improving our products, ADC reserves the right to change specifications without prior notice. At any time, you may
verify product specifications by contacting our headquarters office in Minneapolis. ADC Telecommunications, Inc.
views its patent portfolio as an important corporate asset and vigorously enforces its patents. Products or features
contained herein may be covered by one or more U.S. or foreign patents. An Equal Opportunity Employer
106971AE 10/08 Original © 2008 ADC Telecommunications, Inc. All Rights Reserved
Spec Sheet
Application
The ADC ETP-64 Ethernet termination panel accepts the 50 pin AMP type connectors from the Ethernet
access device (EAD) and transitions to LSA-PLUS NT circuit terminations that are cabled to MDF and
terminated on blocks that support cross connecting to individual circuit assignments.
Ordering Information
Description Catalog Number
ETP-64 Ethernet Termination Panel
64ea. 4-wire Ethernet circuits (128 pairs)
6638 1 128-00
Specifications
PHYSICAL
Dimensions (HxWxD): 1051x560x647mm(5.25x23x8.22inches)
Equipment Side Terminationst: 64ea. 4-wire Ethernet circuits (6ea. AMP 50 pin connectors, male/plug)
MDF Side Terminations: 64ea. 4-wire Ethernet circuits (128 pairs) LSA-PLUS NT IDC terminal blocks
MECHANICAL
MDF Terminations: LSA-PLUS NT disconnect block (white)
Contact Resistance: <1mΩ
Insulation resistance: >5 x 104 MΩ
Contact Material: Copper Alloy
Contact Plating: Sliver
IDC Reterminations: >200
Cross Connect Wire Requirements: 22AWG-26AWG, tinned, cross connect wire for all terminations
EAD Ethernet Access
Device
ADC ETP-64
Ethernet Termination
Panel
MDF Main Distribution
Frame
Cross Connect
To Customer