ADEMCO ADPOWER AD12612 User manual

N9458-1v1 12/95
ADPOWER AD12612
POWER SUPPLY
INSTALLATION INSTRUCTIONS
The AD12612 is an auxuliary power supply/battery charger which provides 6 or
12VDC, 1.2A continuous output to power alarm devices.
INSTALL THE POWER SUPPLY AS FOLLOWS:
1. The AD12612 is factory preset at 13.6VDC, with the jumper set in the 12VDC
position. Move the jumper to the 6VDC position if 6VDC operation is desired (see
Figure 1).
IMPORTANT NOTE: Assure adequate ventilation of enclosure when used
in 6-volt configuration.
2. Connect the proper AC transformer (#1361 for 12V, 1322/TF3 for 6V) to the
terminal block as shown. Do not plug the transformer into an outlet at this
time.
3. Connect the DC output to alarm devices requiring power, carefully observing
polarity.
4. Connect the negative terminal of the DC output to the ground terminal of the
alarm control.
5. Connect a 6 or 12V battery to the battery leads (red to positive, black to negative).
6. Plug the transformer into an uninterrupted 120VAC outlet.
TRANSFORMER: 12VDC Operation: 16.5VAC, 40VA (ADEMCO 1361)
6VDC Operation: 12VAC, 20VA (ADEMCO 1322/TF3)
BATTERY: Standard 4AH gel cell type
FUSE: 3 Amp fast blow fuse, part number FP1166.
AC
AC
DC-
DC+
12V
6V
3A FUSE
VOLTAGE
SELECT
JUMPER
Figure 1: AD12612 Power Supply showing
terminal designations and Voltage
Select Jumper.
ALARM DEVICE MANUFACTURING CO.
A DIVISION OF PITTWAY CORPORATION
165 Eileen Way, Syosset, New York 11791
Copyright © 1995 PITTWAY CORPORATION
ADEMCO LIMITED WARRANTY
Alarm Device Manufacturing Company, a Division of Pittway
Corporation, and its divisions, subsidiaries and affiliates ("Seller"), 165
Eileen Way, Syosset, New York 11791, warrants its products to be in
conformance with its own plans and specifications and to be free from
defects in materials and workmanship under normal use and service for
18 months from the date stamp control on the product or, for products not
having an Ademco date stamp, for 12 months from date of original
purchase unless the installation instructions or catalog sets forth a
shorter period, in which case the shorter period shall apply. Seller's
obligation shall be limited to repairing or replacing, at its option, free of
charge for materials or labor, any product which is proved not in compli-
ance with Seller's specifications or proves defective in materials or
workmanship under normal use and service. Seller shall have no
obligation under this Limited Warranty or otherwise if the product is
altered or improperly repaired or serviced by anyone other than Ademco
factory service. For warranty service, return product transportation
prepaid, to Ademco Factory Service, 165 Eileen Way, Syosset, New York
11791.
THERE ARE NO WARRANTIES, EXPRESS OR IMPLIED, OF
MERCHANTABILITY, OR FITNESS FOR A PARTICULAR PURPOSE
OR OTHERWISE, WHICH EXTEND BEYOND THE DESCRIPTION ON
THE FACE HEREOF. IN NO CASE SHALL SELLER BE LIABLE TO
ANYONE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES
FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR
IMPLIED, OR UPON ANY OTHER BASIS OF LIABILITY
WHATSOEVER, EVEN IF THE LOSS OR DAMAGE IS CAUSED BY
THE SELLER'S OWN NEGLIGENCE OR FAULT.
Seller does not represent that the products it sells may not be
compromised or circumvented; that the products will prevent any
personal injury or property loss by burglary, robbery, fire or otherwise; or
that the products will in all cases provide adequate warning or
protection. Customer understands that a properly installed and
maintained alarm may only reduce the risk of a burglary, robbery, fire or
other events occurring without providing an alarm, but it is not
insurance or a guarantee that such will not occur or that there will be no
personal injury or property loss as a result. CONSEQUENTLY, SELLER
SHALL HAVE NO LIABILITY FOR ANY PERSONAL INJURY,
PROPERTY DAMAGE OR OTHER LOSS BASED ON A CLAIM THE
PRODUCT FAILED TO GIVE WARNING. HOWEVER, IF SELLER IS
HELD LIABLE, WHETHER DIRECTLY OR INDIRECTLY, FOR ANY
LOSS OR DAMAGE ARISING UNDER THIS LIMITED WARRANTY
OR OTHERWISE, REGARDLESS OF CAUSE OR ORIGIN, SELLER'S
MAXIMUM LIABILITY SHALL NOT IN ANY CASE EXCEED THE
PURCHASE PRICE OF THE PRODUCT, WHICH SHALL BE THE
COMPLETE AND EXCLUSIVE REMEDY AGAINST SELLER. This
warranty replaces any previous warranties and is the only warranty
made by Seller on this product. No increase or alteration, written or
verbal, of the obligations of this Limited Warranty is authorized.
Previous Menu