ADIR 613 User manual

Assembly Instructions
for MODEL 613
www.adircorp.comPage 1 of 2
Blueprint Stand with Brackets
Item Description QTY.
AHorizontal
Frame 1
BSide
Frames 2
C Cross Bar 1
DVertical
Frame 1
EHanger 12
FSpring 12
GSetting
Knob 4
HScrew 2
IWasher 2
JLocking
Caster 2
K
Caster
without
Lock
2
LTube Plug 2
M Wrench 1
PARTS LIST
Tools required for assembly: Phillips screwdriver

Assembly Instructions
for MODEL 613
Page 2 of 2
4. Insert Tube Plugs
(Part L) into top of
vertical frame.
2. Screw (Part H -
screws) Cross
Bar (Part C) into
the two side
frames (part B),
Placing the cross
bar between the
two side frames.
www.adircorp.com
Blueprint Stand with Brackets
6. Place spring (Part F)
onto top of hanger
(part E) small end
down (x12). Guide
hanger into holes of
vertical frame, placing
the spring side into
top holes rst, and
then push up hanger
placing the bottom of
hanger into bottom
holes.
A
A
J
F
E
L
G
H
D
G
B
C
B
3. Slide Vertical Frame
(Part D) into lower
frames. Adjust to
paper size. Insert
setting Knobs (Part G)
into socket holes from
back & tighten.
K
1. Slide Horizontal frame
(part A) 6” into (part B)
lower two side frames.
Socket holes should
face down. Insert
setting knobs (part G)
into socket holes.
Do not tighten.
5. Adjust the Horizontal
frame (Part A) to paper
size and tighten the
setting Knobs. Insert the
Locking Casters (part
J) to front of Horizontal
frame. Insert casters
without Lock (part K) to
rear of side frames.