1. Move X and Y Crossfaders to maximum.
(X Crossfader fully up and Y Crossfader fully down)
2. Lower all Scene X sliders to minimum.
3. Raise Scene X slider 1 and 6 to maximum.
4. Raise Scene X slider 7 to 50%.
5. Tap the Program Button. The Program LED should be lit.
6. Tap Bump Button 5.
Flash Scenes:
Flash Scenes that only operates in 1x16 mode. When in the
1x16 mode, the Bump Buttons (10) can be programmed as Flash
Scenes. These are scenes that can be created by any of the 16
channels. Once a Flash Scene is created this scene may be acti-
vate by pressing on the Bump Button it was assigned to. To
create a Flash Scene:
First, use the sliders in the Scene X (2) and Scene Y (11) section
to create a scene. After you have set your scene, tap the Pro-
gram Button to enter the program mode. Once Program mode
has been activated, tap the Bump Button that corresponds to a
Scene Y slider that will be used to store the scene. The scene will
now be stored as a Master Scene into the Scene Y slider and will
be ready for immediate use.
Example:
In this example we will program Bump Button 8, allowing chan-
nels 3, 7, 14 and 15 to be at full, channel 1, 5, 10 and 16 at 50%
output and the remaining channel fully o.
1. Move all Scene X and Scene Y sliders to fully down.
2. Move Scene X sliders 3 and 7 to fully up.
3. Move Scene Y sliders 14 and 15 to fully up.
4. Move Scene X sliders 1 and 5 to 50%.
5. Move Scene Y sliders 10 and 16 to 50%.
6. Tap the Program Button causing its LED to light.
7. Tap Bump Button 8.
Stage Setter 8™ General Operation
ADJ Products, LLC - www.adj.com - Stage Setter 8™ Instruction Manual Page 16
Programming Chase Patterns:
You may create up to 8 Chase Patterns consisting of up to 32
steps (scenes). These patterns are stored in to the Pattern But-
tons (17).
To initiate programming, rst tap the Program Button (14) so that
the Program to activate program mode, the program LED will
glow when program mode is activated. Once program mode is
activated tap the Pattern Button (17) you wish to program to.
Once you selected a pattern bank to store your program the cor-
responding pattern LED will begin to ash indicating which Pat-
tern Button (17) was selected. You may now begin the program
process.
Programming Chase Patterns (2x8 and 8X8 modes):
When in the 2x8 or 8x8 mode, each pattern can only be pro-
grammed using Scene X Sliders (2), and each step will only
includes Channels 1-8.
Example:
Programming a 32 step pattern into the Pattern 5 Bank Button
using the Scene X Sliders (2).
1. Tap the Program Button (4), the program LED will begin to
glow.
2. Tap the Pattern 5 Button (17), the Pattern 5 LED will begin
ashing.
3. Move the desired Scene X Sliders (17) to the levels desired as
the rst step of this pattern.
4. Tap the Program Button (4) to program this step into memory,
all channel LED should ash once and the LCD (7) will read
“01”.
5. Repeat steps 3 and 4 until the LCD (7) reads “end.” End will
denote the maximum of 32 steps has been reached.
6. After the maximum of 32 steps has been programmed, pro-
gram mode will automatically release.
7. If you wish to program less steps in to your program, you can
Stage Setter 8™ Basic Programming
ADJ Products, LLC - www.adj.com - Stage Setter 8™ Instruction Manual Page 17
