Admiral STRONG GIRL User manual

Admiral Staging Essentials the Netherlands
www.admiralstaging.com [phone]
ZEM2SV36
ASSEMBLY KIT
STRONG GIRL
The intended use of ADMIRAL Stong Girl is to transport 30 or
40 circular truss sections with a square cross section. The
diameter may vary from 2,5 m up to 20 m, where the length
of the truss sections does not exceed 3 m.
Length profile: ZEWASGL15
(length profile strong girl)
Width profile: 30 truss: ZEWASGW3
40 truss: ZEWASGW4
Truss carrier: 30 truss: WASGC30
40 truss: WASGC40
Castor: 125 with break: ZEWACW24
Bolt set: ZEM2SV36
SCOPE
CONTENT
1
2
3
4
5
STEP 1 BUILDING THE FRAME STEP 2 PLACE THE TRUSS CARRIER
4X
1
Ø of truss circle is:
12.5m up to 5m
25m up to 7.5m
37.5m up to 10m
4> 10m
First, determen the location of the carrier using the table.
ASSEMBLY
M8 x 16
(16x)
INSIDE
234
1
2
34

Don’t load higher than 2 meters to prevent instability.
Always keep the dolly on a flat surface
max 2 m
OPTION 1
Use ADMIRAL truss carriers to load the truss.
OPTION 2
If the diameter of your truss is to small for a regular
truss carrier, use a Strong Girl truss carrier (WASGC30
for 30 truss or WASGC40 for 40 truss) with 4 half
conical couplers added.
LOADING AND SAFETY
ALWAYS SECURE THE LOAD
Use ADMIRAL truss carriers to load the truss.
OPTIONAL
STORAGE PLATE
A bottom plate can be assembled for transporting
carriers and straps onto the Strong Girl. Holes for screws
are already available on the frame. Make cuttings into
the plank in order to keep the inside slots for your cable
straps open.
SIDE PANELS
Side panels can be mounted onto
the frame, by using the Admiral Freedom
profiles. We advise you to brace the wooden
board sufficient and cut lifting recessions.
MAINTENANCE
The Strong Girl hardly needs any maintenance under normal use and environmental circumstances.
For safety reasons however, all parts must be checked regularly for dirt, damages, loss and corrosion.
• Check all components for damage and corrosion. Damaged and corroded parts shall be rejected and thrown away.
• Remove all sharp edges and burrs with a piece of sanding paper.
Replaced component shall be genuine ADMIRAL only. Check Content 4 for replacement parts.
Outside the frame Inside the frame
WARNING