ADTRAN 424RG User manual

Fiber Internet - Router Information Sheet
Description:
Your new router is the ADTRAN 424RG model. It features four Ethernet ports, both
2.4GHz and 5GHz Wi-Fi, and two POTS/Phone ports.
•2.4GHz Wi-Fi has a greater range but lower speed.
•5GHz Wi-Fi has a lower range but greater speed.
•For the highest speeds, plug devices into the router via an ethernet cable.
Connecting to the Internet:
You are able to connect to your router either through an ethernet cord that plugs
from the router directly into your devices, or through one of two Wi-Fi channels.
- To connect through Wi-Fi, select the ADTRAN wireless network through your
device and enter the password listed on the sticker on the router.
- If you are plugging directlyinto the router, there is no password and most modern
devices connect automatically. However, if you need to access your network
settings:
•On PC - Open Control Panel, select Network and Internet, then Network
and Sharing Center.
•On Mac –Click the System Preferences icon in the Dock and choose
Network. Select Ethernet from the list on the left of the pane to display the
settings.
Warnings:
•Do not disconnect or bend the fiber cable from the wall outlet or router.
Doing so may cause the cable to become dirty or break.
•Do not use the reset button on the back of the router, this will make you lose
the router’s configuration and Internet service.
•If the fiber cable becomes disconnected, do not look into the end of the
cable as this could cause eye damage.
•Always use the provided stand and keep the router upright. Laying the
router flat will cause it to overheat.
Resetting the Router:
•To reset the router, simply unplug the 12V power adapter, leave unplugged
for 5 minutes, then plug it back in. Do not unplug the fiber cord.

FRONT BACK

Changing Wireless Passwords:
1. Using a web browser, log into the router by typing the address 192.168.1.254.
On the login that pops up, the username is “user” and the password is also
“user” by default. This will allow you access to the necessary menus to change
the SSID’s and passwords.
2. To change the wireless Name (SSID), click the “Wireless” link on the left of the
screen, then select either the link for 2.4GHz or 5GHz. Enter the new SSID and
click Apply/Save.

3. To change the Password, select the “Security” section. Enter the new
Password in the WPA/WAPI passphrase box as seen below. Click Apply/Save.
Changing Router Login:
While logged into the 192.168.1.254 as above, clicking on the “Management” link,
and then “Passwords” will allow you to input a new User Name and password to
access the router. This will make your router more secure so that only you can
access these pages, and no one else can change your settings.
Contact Information:
City Hall Fiber Office Number –[phone]