SIMB-M02
Intel® Atom Cedar View
Mini-ITX Motherboard Startup Manual
Packing List
Before you begin installing your card, please make sure that
the following items have been shipped:
• 1 x SIMB-M02 Mini-ITX Motherboard
• 1 x CD ROM per carton, which contains Drivers
• 1 x SATA cable kit (SATA/Power)
• 1 x I/O Shield
• 1 x Startup Manual per carton
If any of these items are missing or damaged, please contact
your distributor or sales representative immediately.
Note1:
Acrobat Reader is required to view any PDF file. Acrobat
Reader can be downloaded at: www. adobe.com/Prodindex/
acrobat/readstep.html (Acrobat is a trademark of Adobe).
Disclaimer and Notice
The manufacturer reserves the right to make changes, with-
out notice, to any product, including circuits and/or software
described or contained in this manual in order to improve
design and/or performance. The manufacturer assumes
no responsibility or liability for the use of the described
product(s), conveys no license or title under any patent,
copyright, or masks work rights to these products, and
makes no representations or warranties that these products
are free from patent, copyright, or mask work right infringe-
ment, unless otherwise specified. For the detail product
information, please refer to user’s manual.
Safety Declaration
This device complies with the requirements in Part 15 of
the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.
For more information on this and other Advantech
products, please visit our website at:
http://www.advantech.com
http://www.advantech.com/eplatform
For technical support and service, please visit our
support website at:
http://www.advantech.com/support
This manual is for the SIMB-M02 series Rev. A1.
Part No. 20060M0200
Printed in China 1st Edition
June 2012
Specifications
System
•CPU: Intel Cedar-View,
Cedar View-M (2600), or
Cedar View-D (D2550)
• FSB: x4 DMI for Cedar View-D or Cedar View-M
• BIOS: FHW 16 Mb SPI BIOS
• System Chipset: Intel NM10
• I/O Chipset: Winbond 83627DHG
• Memory: One 204-pin SO-DIMM sockets support up to
2GB Single Channel DDR3 800/1066 MHz SDRAM (N2600)
4GB Single Channel DDR3 800/1066 MHz SDRAM (D2550)
• Watchdog Timer: Reset: 1sec.~255 min. and 1sec. or 1
min./step
• H/W Status Monitor: Monitoring temperature, voltage and
cooling fan status. Auto throttling control when CPU overheats
• Expansion Slots: 1 Mini PCI-E, 1 Cfast , 1 PCIEX1
• DIO: 8 bit
• S3 / S4: Yes
• TPM: Optional
• Wake up on LAN or Ring: LAN (PME / RPL)
• Smart Fan Control: Yes
Display
• Chipset: Intel GMA HD3650 (D2550) / HD3600 (N2600)
• Max. Resolution: 1920 x 1200 (@60Hz)
• VGA: Yes, Integrated Graphics
• LVDS:
D2550 : Onboard single channel 18/ 24-bit LVDS, supports
max resolution 1440 x 900
N2600 : Onboard single channel 18/ 24-bit LVDS, supports
max resolution 1366 x 768
• HDMI: Onboard HDMI 1.3 support max resolution 1920 x
1200
• Dual Display: VGA + HDMI; VGA+LVDS; HDMI + LVDS
Audio
•Audio Codec: Realtek ALC892-GR, 5.1 Channel HD Audio
• Audio Interface: Line-in, Line-out, Mic-in, Front Audio
Header
Ethernet
•LAN1: Realtek 8111E Gigabit Ethernet
•LAN2: Optional
SIMB-M02StartupManual1
