Advantech SIMB-M22 Installation and operation manual

SIMB-M22 Startup Manual 1
Before you begin installing your card, please make sure that
the following items have been shipped:
• 1 x SIMB-M22 Mini ITX Main board
• 1 x CD-ROM per carton, which contains the followings:
- User’s manual
- Drivers
• 1 x SATA cable kit (SATA/POWER)
• 1 x I/O Shield
• 1 x Startup Manual per carton
If any of these items are missing or damaged, please con-
tact your distributor or sales representative immediately.
Note1:
Acrobat Reader is required to view any PDF file. Acrobat
Reader can be downloaded at: www. adobe.com/Prodindex/
acrobat/readstep.html (Acrobat is a trademark of Adobe).
SIMB-M22
AMD G-Series™ APU with A55E Controller
Hub(FCH) Mini-ITX Motherboard
Startup Manual
System
• APU:AMD G-Series T40R SC 1.0GHz
• FCH:AMD A55E Controller Hub (Hudson-E1)
• BIOS:AMI 16Mb SPI
• SystemChipset:AMD G-Series + A55E Controller Hub
• I/OChipset:Winbond W83627DHG-P
• Memory:One 204-pin SODIMM sockets support up to 4
GB DDR3 1066/1333 MT/s
• SSD:N/A
• WatchdogTimer:Reset: 1 to 255 sec/min per step
• H/WStatusMonitor:Monitoring temperature, voltage
and cooling fan status. Auto throttling control when CPU
overheats
• ExpansionSlots:1 PCI-E x4 Gen.2, 1 Mini PCI-E
• PowerState:S3, S4, S5
• WakeuponLANorRing:LAN
• SmartFanControl: Ye s
Display
• Chipset:AMD Radeon HD 6250
• DisplayMemory:Shared Memory, up to 512MB
• DualDisplay:VGA+LVDS, VGA+HDMI, HDMI+LVDS,
eDP+HDMI, eDP+VGA
• VGA:Onboard, supports up to 1920 x 1200
• HDMI:Onboard, supports HDMI 1.3a & up to 1920 x 1080
• LVDS:Onboard, 18-bit single channel LVDS
• LVDSBacklight:Yes, PWM Control (Backlight adjusted
from AMD A55E Controller Hub)
• eDP:Onboard optional (18,24,30 bpp up to 1920 x 1200 )
Audio
• AudioCodec:Realtek ALC892, 7.1 Channel HD Audio
• AudioInterface:Line-in, Line-out, Mic.-in, S/PDIF, Front
Audio Header
Ethernet
• LAN1/LAN2:Realtek RTL8111DL GbE LAN
Specications Packing List
For more information on this and other Advantech
products, please visit our website at:
http://www.advantech.com
http://www.advantech.com/eplatform
For technical support and service, please visit our
support website at:
http://www.advantech.com/support
This manual is for the SIMB-M22 series Rev. A1.
Part No. 20060M2210
Printed in China
1st Edition
August 2011

2 SIMB-M22 Startup Manual
Jumpers
Label Function Note
CLRTC Clear CMOS
Norrnal* Clear CMOS
JSETCOM3 COM3, COM4 RI/+5V/+12V
COM3
RI +5V +12V
JSETCOM4 COM4
RI +5V +12V
PSON1
AT/ATX Mode Select AT MODE ATX MODE
JBL3 LCD POWER (VDDSAFE)
3.3V 5V
Connectors
Label Function Note
COM3, COM4 Serial Port Connector
COM3 COM4
JFP1+JFP2 System Panel & Speaker
PIN7-10 Internal SPK PIN3-6 POWER BT
PIN1-10 External SPK PIN9-12 SYS_RESET
JFP3 Power LED & Keylock
Connectors and Jumpers

SIMB-M22 Startup Manual 3
Connectors and Jumpers
LVDS 1 18-bit LVDS Connector
JBL1 Inverter PWR
CN4 SPI connector
AAFP Audio Mic.-In & Line-Out
Connector
SPDIF_OUT1 SPDIF OUT
CN10 Amp_R+ R-/ Amp_L+ L-

4 SIMB-M22 Startup Manual
The manufacturer reserves the right to make changes, with-
out notice, to any product, including circuits and/or software
described or contained in this manual in order to improve
design and/or performance. The manufacturer assumes
no responsibility or liability for the use of the described
product(s), conveys no license or title under any patent,
copyright, or masks work rights to these products, and
makes no representations or warranties that these products
are free from patent, copyright, or mask work right infringe-
ment, unless otherwise specified. For the detail product
information, please refer to user’s manual.
Safety Declaration
This device complies with the requirements in Part 15 of
the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Board Diagram
Disclaimer and Notice