Adventure Kings AKEP-LJS1000A 01 User manual
USER MANUAL
SKU: AKEP-LJS1000A_01
1000A LITHIUM JUMP STARTER
2V1.1
CONTENTS
PLEASE READ AND UNDERSTAND THIS MANUAL
COMPLETELY BEFORE USING THIS PRODUCT.
1. SAFETY INFORMATION 3
2. FEATURES 4
3. OPERATION 5
3.1 Smart Clamps 5
3.2 Charging Your Jump Starter 5
3.3 Starting Your Vehicle 5
3.4 Charging Mobile Phones 6
3.5 Using the LED Torch 6
4. FAQ’S 6
5. TROUBLESHOOTING 7
6. SPECIFICATIONS 7
7. WARRANTY 8
3V1.1
1. SAFETY INFORMATION
WARNING: FAILURE TO FOLLOW SAFETY
INFORMATION MAY RESULT IN FIRE OR EXPLOSION!
Always follow safety precautions when using electrical equipment.
Please keep this instruction manual with the jump starter at all times.
Ensure the jump starter and all accessories are in good working order before each use. This product is
designed for 12V vehicles only.
Once vehicle is started, remove the jump starter as soon as possible to prevent possible damage to the unit.
• DO NOT connect the two clamps together.
• DO NOT modify or disassemble the jump starter.
• DO NOT operate near flames or flammable objects.
• DO NOT expose the unit to extreme heat.
• DO NOT allow overheating.
• DO NOT overcharge.
• DO NOT expose to heat or fire. Avoid storage in direct sunlight.
• DO NOT short-circuit. Do not store haphazardly in a box or drawer where damage and/or short-
circuiting may occur.
• DO NOT subject cells or battery to mechanical shocks or damage.
• In the event of battery leakage, do not allow liquid to contact skin or eyes. If contact made, wash
affected area with copious amounts of water and seek medical advice.
• DO NOT use any charger or electrical cables/clamps other than those specifically provided.
• In use, make sure cables are fully inserted into sockets, and make sure clamps are properly connected
to battery terminals.
• Provide a two-minute cool-down break between attempts at starting a vehicle.
KEEP PRODUCT AWAY from children.
4V1.1
2. FEATURES
ITEM FEATURE
1 LED Torch
2 USB 1 - 5V/2A
3 USB 2 - 9V/2A
4 Smart Clamp Port
5 Power Button
6 LED Display
7 Input - 9V/2A
8 Output - 12V/8A
4
1
2
3
7
8
5
6
5V1.1
3. OPERATION
You can charge your jump starter by either:
1. Using the supplied 240V AC charger
2. Using the supplied 12V Cigarette plug lead.
3.2 CHARGING YOUR JUMP STARTER
3.3 STARTING YOUR VEHICLE
STEP
3
STEP
4
STEP
1
STEP
2
Once the vehicle has started, disconnect the jump starter from the battery as soon as
possible.
Connect the RED (positive) clamp to the vehicle’s positive ( + ) terminal and connect the
BLACK (negative) clamp to the vehicle’s negative ( - ) terminal.
Insert the battery clamp plug completely into the jump starters starting port.
Ensure that the jump starters power level is not lower than 50%, or you may not be able to
jump start the vehicle.
The Jump Starter features a smart clamp system to provide Low Voltage, Reverse Polarity, Short Circuit,
Reverse Charge and Automatic Power Shut off Protection.
3.1 SMART CLAMPS
6V1.1
1. Double press the power button. The LED torch will then turn on.
2. Press the power button again to activate the strobe function.
3. Press the power button again to activate the SOS function.
Q: HOW DO YOU TURN OFF THE JUMP STARTER?
A: This product will power off automatically when no load is detected or when charging is complete.
Q: HOW LONG DOES IT TAKE TO FULLY CHARGE THE JUMP STARTER?
A: Around 7 hours
Q: HOW MANY TIMES CAN THIS JUMP STARTER CHARGE MY PHONE?
A: Dependent on the phones battery capacity this jump starter can charge most smart phones 3 to 4 times.
3.5 USING THE LED TORCH
4. FAQ’S
Use either the provided or your own USB charging cable.
Connect the cable to either USB ports whilst connecting the other end to your device. If you are using the
provided USB charging lead ensure you select the correct connection for your device.
• DO NOT charge more than 1 device at a time with the provided USB break out charging cable.
• DO USE both USB outlets at the same time if required.
Press the power button on the jump starter unit to begin charging your device
3.4 CHARGING MOBILE PHONES
7V1.1
6. SPECIFICATIONS
DIMENSIONS 193(L) x 89(W) x 48(H) mm
INTERNAL BATTERY Lithium Ion Battery
CAPACITY 12,000mAh / 44.4Wh
STARTING CURRENT 500A
PEAK CURRENT 1000A
USB OUTPUT 1 5V / 2A
USB OUTPUT 2 9V / 2A
INPUT Type - C Plug 9V / 2A
SAFE OPERATING TEMPERATURE -20°C ~ 60°C
5. TROUBLESHOOTING
ISSUE CAUSE SOLUTION
No response when pressing the
power button
Low voltage protection is
preventing the device from turning
on
Charge the device
LED INDICATOR SITUATIONS
The green and red light will flash for 1-3
seconds, and then the green light will stay
on when connected to the car battery
Ready to jump start.
The red light is always on
Check whether the clamp is reverse connected.
Check the clamp is not short-circuiting.
Check if the two clamps are connected together or if both
clamps are connected to the same piece of metal.
The red light flashes quickly The temperature of the clamp exceeds 65(+/-5) degrees.
Remove the clamp until the red/green light flash.
The green light flashes slowly The voltage of the jump starter is too low.
Charge the jump starter.
8V1.1
7. WARRANTY
WARRANTY PERIOD:
Full 12 month warranty from date of purchase against all manufacturing defects.
WHAT DOES THE WARRANTY COVER?
Under normal usage conditions, this warranty covers:
a. Any defect in design or manufacture which results in the product failing to perform substantially as described
in authorised advertising or literature.
b. We will either repair or replace the product at our discretion providing that the fault is found to have been
caused by a design or manufacturing defect and not misuse or tampering.
Our goods come with guarantees that cannot be excludedunder the Australian ConsumerLaw. You are
entitled to a replacement or refund for a major failure and for compensation for any other reasonably
foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be
of acceptable quality and the failure does not amount to a majorfailure. The benetsprovided to you as the
consumer by this warranty are in addition to other rights and remedies available to you under the law.
THE WARRANTY DOES NOT COVER:
a. Any damage resulting from improper use
b.
c. The cost of removing and reinstalling the product
d. Travel and /or other expenses due to customer’s remote location
e. Transport charges and damage in transit. It is your responsibility to deliver and pick up your product,
including any costs associated with the postage of your repair or replacement product. If you do freight your
product we recommend that you insure against loss or damage.
f. Any loss directly or indirectly associated with the product failing to operate.
g. Damage caused by mould, insects, animals, misuse, incorrect operation, adverse weather, accidents
and fair wear and tear
TO MAKE A CLAIM, PLEASE ENSURE YOU RETAIN YOUR SALES RECEIPT OF PURCHASE
1800 88 39 64
12 MONTH LIMITED
WARRANTY
OUTDOOR SUPACENTRE PTY LTD
Level 1, Building A, 6 Figtree Drive,
Sydney Olympic Park, NSW 2127, Australia
PHONE: 1800 88 39 64
www.4wdsupacentre.com.au
Faulty installation or modication made during installation
Table of contents
