AerAtron Ceiling Extension User manual

IMPORTANT - Use this Ceiling Extension Instrucon in
combinaon with the Aeratron User Manual by Inserng
aer STEP 2 of the User Manual supplied with the Fan.
Ceiling Extension Instruction
Unpack your EXTENSION KIT and examine all parts, you should have the following:
EXTENSION CANOPY
DECORATION RING
CANOPY SCREW X2
EXTENSION COVER
EXTENSION ROD
EXTENSION BRACKET
BRACKET SCREW X2
SAFETY CLIP X2
PLEASE NOTE: A small colour variaon between the Fan and the retrofit Extension Parts is part
of standard manufacturing tolerances and consequently will need to be accepted by the user.
!
1

2
STEP 2 Fit Extension Bracket and Rod
STEP 1 Remove Suspension Ball
Fit Extension Bracket to
motor Sha.
Insert Bracket Screw
Tighten two Lock Screws
Remove Suspension
Ball Screw
Push Suspension Ball down Remove suspension Bolt
and Suspension Ball from
Motor Sha
Insert Safety Clips
into Bracket Screws
Fit Extension Rod to
Extension Bracket.
Insert Bracket Screw
Tighten two Lock Screws
B C
3
1
1 4
5
7
6
2
3
2
3
4
5
6
6
7
A

A
B
3
STEP 4 Fix Canopy Screw to Hanger Bracket
STEP 3 Assemble Extension parts to Extension Rod
Suspension Bolt
Suspension Ball
Suspension Ball screw
Extension Canopy
Canopy Screws
Decorang Ring
(holes facing canopy)
Extension Cover
~2mm (5/64”)
Fix one Canopy Screw
to Hanger Bracket.
Leave a 2mm gap to
the Hanger Bracket
Insert the Suspension Bolt.
Raise the Suspension Ball to
cover the Suspension Bolt and
ghten the Suspension Ball Screw.

BA
4
STEP 6 Attach Canopy and Decoration Ring
STEP 5 Position the Motor Assembly in Hanger Bracket
!
=
Ensure that lug on Hanger Bracket
is engaged in slot in suspension Ball
Connect Mains Power Connector
to Fan Motor Extension plug.
1
Push Canopy up and rotate clockwise on
exisng Canopy Screw.
Insert second Canopy Screw & ghten both.
1
2
Line up large holes in Decoraon
ring with screw heads, push up and
rotate counter clockwise.
3
23
Note: Move / swivel the motor assembly sideways for easy canopy screw access.

Slide Remote Control Receiver
into Hanger Bracket in the orientaon
as shown above.
Allow the Mains cable free movement
between the Bracket and Receiver.
STEP 7 Install Receiver into Extension Bracket
IMPORTANT - Connue at STEP 5 (Connecng the Reciever) of the
User Manual supplied with the fan to complete the installaon.
!
Thank you. Your Aeratron team.
Ceiling Extension Edion 2021/06
For General Informaon & Warranty issues refer to the Aeratron™ User Manual available at www.aeratron.io
5