Click Action
Button/S1/S2 3x times in
2 seconds.
1. Enter Shutter Calibration Mode
Orange light flashing when calibrating.
1. Press the Button/S1/S2 once when
blinds arrive at max close.
2. Press the Button/S1/S2 again when
blinds arrive at max open.
3. LED will stop when calibration is done.
2. Exit Calibration Mode
Calibration incomplete - goes back to the
rainbow color cycle.
1. Enter Shutter Calibration Mode
Orange light flashing when calibrating.
1. Press the Button/S1/S2 once when blinds
arrive at max close.
2. Press the Button/S1/S2 again when
blinds arrive at max open.
3. LED will stop when calibration is done.
2. Exit Calibration Mode
Calibration incomplete - goes back to the
rainbow color cycle.
Click Action
Button/S1/S2 4x times in
2 seconds
S2(External switch 1) Identify Mode
LED will flash green: when it is in S2 external
switch identify Mode.
Toggle or press the external switch
connected to S2.
Solid green LED (2 seconds): success in
external switch S2 detection.
Solid red LED (2 seconds): Failure in external
switch S2 detection.
S2(External switch 1) Identify Mode
LED will flash green: when it is in S2 external
switch identify Mode.
Toggle or press the external switch
connected to S2.
Solid green LED (2 seconds): success in
external switch S2 detection.
Solid red LED (2 seconds): Failure in external
switch S2 detection.
Click Action
Button/S1/S2 5x times in
2 seconds.
1.Enter Venetian Calibration Mode
White light flashing when calibrating.
2.Exit Calibration Mode Calibration
incomplete
- goes back to the rainbow color cycle.
1.Enter Venetian Calibration Mode
White light flashing when calibrating.
2.Exit Calibration Mode Calibration
incomplete
- returns to default LED state.
Click Action
Button/S1/S2 6x times in
2 seconds.
Nothing. Sends NIF to controller (used for
unpair/exclusion):
If Removing succeeds, it will become a
rainbow color cycle.
If Removing fails, it will return to the default
LED state.
Press and hold
Action Button/S1/S2
press for [20 - ∞)
Factory Reset:
LED will become solid green for 2 seconds,
Nano Shutter will manually factory reset itself,
and issue a Device Reset Locally Command
via its Lifeline to your Z-Wave Controller.
LED will return to an unpaired rainbow cycle
state, the device will auto-reset and then active
SmartStart Learn Mode again.
Factory Reset:
LED will become solid green for 2 seconds,
Nano Shutter will manually factory reset itself,
and issue a Device Reset Locally Command
via its Lifeline to your Z-Wave Controller.
LED will return to an unpaired rainbow cycle
state, the device will auto-reset and then active
SmartStart Learn Mode again.
