AFF Flanders AstroPure 500-IR User manual
Portable Air Purification Systems
Quick
Start
Guide
AstroPure@aafintl.com
9920 Corporate Campus Drive, Suite 2200, Louisville, KY 40223-5690
888.223.2003 Fax 888.223.6500 | aantl.com
AFP-1-804 05/21
Important notes:
•Prior to operating this AstroPure air purification system, please read and
observe all safety and installation instructions provided in the Introduction
and Installation Instructions section of the Installation, Operation, and
Maintenance (IOM) manual that came enclosed with the system.
•This guide is meant to expedite setup and operation of the system following
installation and using the default settings.
•For more detailed information on setting up, operating, and maintaining this
system, please consult the IOM manual or contact AstroPure@aafintl.com.
After completion of installation, turn on the power switch located on the
back of the unit.
a. The unit is preset to 60% of maximum power.
b. To make adjustments to the CFM settings, refer to the EC Motor
Speed Adjustment section of the IOM manual.
When the power cord is plugged into a wall receptacle, and the power
switch is in the ON position, the control panel (HMI) will sound an
audible confirmation and illuminate.
The system starts with the fan in the OFF position. To turn it on, press
the red power button that is part of the control panel (HMI) on the top of
the unit.
a. The EC motor may require time to ramp up to full operating
speed (RPM).
b. If the motor does not seem to be running upon turning on the unit,
allow ten (10) seconds for the motor to get up to full operating
RPM. If nothing happens, go to the troubleshooting section in the
IOM manual.
1
2
3
This manual suits for next models
3
