AGPtek TT3 User manual
TT3
IR Infrared Remote Control Repeater Emitter Extender
Adapter
Does your entertainment system have wooden doors or would you like to
mount your components in a closet? Put all of your AV gear in a closet or in a
chest, or even in another room, totally out of view and control it with your IR
remote controls.
Feature:
High sensitivity
Remote control signal receiving real-time response to fast forward
without delay
CFL friendly
This unit can be installed in an area with compact uorescent lighting,
and will ork in most lighting environments
IR Status LED
Blue IR LED con'rms the signal is being transmitted
ide Band IR
ide Band IR receives infrared signal from many types of remotes
Compact size
ith the small size of the connecting block, you can mount it near audio
equipment with nearly no visibility
Low power consumption
12VDC, 30mA max
Compatible:
DVD, IP V, Fans, Air-conditioner, Satellites Receive Equipment, which’s
receiving and transmitting frequency range are available.
Specification:
Receive Frequency Range 34 KHZ to 60KHZ
ransmit Frequencies 38 KHZ & 56KHZ
Receive Range 8 Meter
Emitter Range 5-10CM
Power 12VDC,30mA MAX
Dimensions (IR Receiver) 31(L)×17(W)×13(H)mm
(IR Emitters)
(IR Connecting Block)
13L)×8(W)×5.5(H)mm
90(L)×55(W)×26(H)mm
Cord Length (IR Receiver)
(IR Emitters)
1.5 Meter
3 Meter
Connector ype 3.5mm mini plug
Weight (IR Receiver)
(IR Emitters)
(IR Connecting Block)
0.03Kg
0.03Kg
0.15Kg
Package Include:
1 x IR Distribution Block
1 x IR Receiver
4 x IR Emitter
1 x DC 12V Adapter
1 x Operation Manual
Note:
Before bid, please make sure receiving and transmitting frequency range are
compatible. he receive range is about 8 meter, please make sure it’s enough
for your house.
ow to Use:
Note: Careful consideration must be taken when placing the IR Receiver near
a Plasma Display!
Plasma Displays emit IR frequencies during use and may cause interference.
Put the IR emitter as far as possible from the plasma display screen.
he Connected Remote Control Repeater is shown in the picture below:
1. ake the Mini IR Receiver (up to three) and connect it to the IR Receiver
input jacks labeled 1-3 on the IR Connecting Block.
2. Connect the emitters (up to six) to the emitter jacks labeled 1-6 on the IR
Connecting Block.
3. Place the emitters on the source equipment.
4. Connect the 12VDC/ 5V USB Power Supply to the power jack on the IR
Connecting Block and plug the Power Supply in the wall outlet. he LED
will illuminate with a red light letting you know power is connected.
5. When the LED is green, it means that the power has been connected
successfully .When an IR signal is received, the IR confirmation red LED will
flash.
描描描描描描描描描描
描描描描描描描描描描描描描描描描描描
Table of contents
