6
Caution: Avoid eye or skin exposure to direct radiation.
Away from children.
Always wear protective glasses when use the machine.
Prohibited from use in flammable objects or gases.
In case of emergency, cut off the power immediately.
Shutdown steps: When you are not using the machine, first cut off the
power, then turn off the software, at last dial out the USB cable.
Safety Guide
1. When the laser engraver is working, the operator should not leave it, just in case the materials
being carved catch fire.
2. When the laser engraver is in use, wearing laser safety glasses is mandatory for the operator as
well as any person in the proximity of the machine. Our Ahwoo Laser Warrior ships with a pair of
goggles but additional laser safety glasses can be purchased commercially. Goggle Requirements:
WaveLength Protection 400-445nm (+-5nm), O.D.+5, L-Rating Minimum required L5
3. Use the laser engraver in a room that can be closed by a door and ensure that neither laser
beams nor stray light can penetrate through the windows.
4. While using the laser engraver, use door signs or a warning light on the door that indicates the
laser engraver is in operation.
5. Make sure that there are no flammable materials near the laser engraver, we recommend the
use of a fireproof pad as a work surface.
6. When operating the laser engraver, ensure that there is adequate ventilation. Engraving certain
materials might produce smoke that should be evacuated by the use of a dedicated filtered Air
Extracton.
7. Do not reach or touch the laser beam or use tools while machine is operating. This can result in
severe burn injuries or reflection of the beam
8. Do not let children or adolescents work alone with the laser engraver. Adult supervision is
required at all times
9. For commercial use, the use and registration of supervisory authority and the professional
association is mandatory.
Safety instructions when using the laser engraver
