Tower Strobe
Strobe / Illumination Light Wiring Instructions
The following instructions are for wiring the beacon /strobe light on top of TW-Series towers, as well
as wiring the panel light located above the station mounting hole.
These instructions apply to models: TW-LCB, TW-LCK, TW-LCR, TW-LCW, and TW-LCY.
Locate the beacon/strobe wires and connect to a 24V DC power supply.
• Red to +24V DC
• Black to - (Ground)
• Connect the white trigger wire to one side of a Normally Open (NO) relay on the emergency sub
station. Connect the other side of the Normally Open (NO) relay to the positive of the 24V DC
power supply.
Locate the panel light wires and connect to a 24V DC power supply.
• Red to +24V DC
• Black to - (Ground)
+
-
24VDC
Panel Light
Strobe
Refer to the sub station installation manual for its
complete wiring and dip switch setting options.
Pg. 1
Relay board on back
of IX-RA sub stations
