AIR GAP TAP-A-FLOW AG250-103 User manual
TAP-A-FLOW™
KITCHEN PEDAL WITH
CONSTANT FLOW LOCK
STAINLESS STEEL FINISH
Placentia, California
Model:
Part No.
AG250-103
Doc. # 400-0788-001
Copyright 2018 AIR GAP INTERNATIONAL
During installation, avoid bending valve actuating. Any bending needs to be
smooth.
CAUTION:
AG250-103
Press the pedal on right side to lock in open position, open the
faucet, and adjust it to the desired water temperature and flow rate.
As long as the pedal is depressed, water will flow from the faucet.
When the pedal is released, the water flow stops.
4.
To release the pedal, press on the left side.
2 – #10 Mounting screws
1 – Pedal assembly
Installation Procedures
AG250-103
LIST OF PARTS ENCLOSED
The AG250-103, in combination with
AG250-002 valve, provides hands-free
faucet operation.
AG250-103 has constant lock option.
Valve is ordered separately.
Please read the instructions once through before starting.
PEDAL INSTALLATION INSTRUCTIONS
-OVER-
Apply top mounting plate at
the edge of the cabinet and
mark position of mounting
screws.Drill two holes for #10
screws. (13/64"). (FIG.1)
Measure 1-3/4" from the
bottom of cabinet aligned with
the top mounting plate,drill 1"
hole under the cabinet plate.
(FIG.1)
1.
AG250-002
Cold/Hot Potable Water
Mechanical Valve
1 – Top mounting plate
Pass cable from the AG250-002 valve through the 1"
opening under the cabinet plate and connect it to the
pedal AG250-103.
2.
Unscrew the front nut (1) on the valve cable and insert the
cable (4) through the slot on the back side of support
bracket AG250-103 pedal. The rear nut (3) remains at the
end of the thread (2). Adjust cable holder (2) for proper
pedal operation and secure its position with nuts (1) and
(3).Control cable (4) should be snug. (FIG. 2)
Verify that valve actuating cable is inside the valve
receptacle. (FIG.3)
Insert valve cable end T-bar (5) into the pedal
lever (6). (FIG. 2)
FIG. 2
3
2
4
5
FIG. 1 FIG. 3
Use provided #10 screws to attach the pedal.
(FIG.4) Pedal position can be adjusted using
four screws (7) on side of pedal assembly.
(FIG. 2)
3.
FIG. 4
6
AG250-103
Pedal
1
7
1-3/4"
1" Diameter
Openings for
#10 screws
