AIR-GRAPHICS Aegean Hawk User manual

1:72
Scale
CS-22
Conversion Set
Aegean Hawk
Sikorsky S-70B-6
∐∏‑
52

S-70B-6 Aegean Hawk 4 View Drawings showing the airframe modifications.
Drawings Copyright
Gary Madgwick &
Air Graphics 2021
56
7
8
9
10 & 11
12
13
14 & 15
This conversion set is designed around the
Hobbyboss Seahawk but is can be used on the Hasegawa
or Italeri kits with some minor modifications. Please
note there is a late model update which is not
included in this set.
1
2
3
4
5
6
16
17 & 18
19 & 20
12
13
123
1
21
7 & 8
7 & 8
17 & 18
22
23
24 (Optional)
25
22
23
4
24 (Optional)
26
27
Jammer
Note revised aerial
Arrangement. Make from
Plasticard and stretch sprue
Note fuel vent pipe.
Note position
of Anti
collision light
Jammer
Note* Parts 28, 29, 30-33
Are not shown on these
Plans.
Part 28 Long range fuel tank
Part 29 Penguin Missile
Parts 30-33 Penguin missile fins
12
13
17 & 18
Please note that we are planning
an interior detail set and decals
For the Aegean Hawks
34
35
CS-17 S-70B Seahawk engine detail
Set is also available.

Photos: Hellenic Navy, Konstantinos Panitsidis,
Philip Luejar, helis.com, Ivan Bukvic, Milavia.com,
Gary Madgwick Collection.

Air-Graphics: 24 Fyfield Close, Wantage, Oxfordshire,
OX12 8HN, UK.
E: [email protected]
INSTRUCTIONS
• Remove any flash by gently snapping off, or cutting
with a scalpel and then lightly sanding.
• Only use Super-glue or a two-part epoxy glue to fix
parts.
• Gluing is easier if mating surfaces are slightly sanded
to roughen the resin before gluing. Also clean off any
dust before gluing.
• Before paining, thoroughly wash all parts in warm
water with detergent.
• We recommend the application of a base coat in a
light colour to show any blemishes prior to final painting.
WARNING & SAFETY!
• These parts are moulded in polyurethane resin.
Please take care when sanding and cleaning up the
resin by wearing a dusk mask or other protective
breathing device to avoid inhalation of the dust
particles.
• Wash hands, resin parts and the work surface after
sanding resin.
• When using Super-glue or two-part epoxy glue, please
take precautions to avoid contact with skin and eyes.
• It is also advisable to wear a mask to avoid breathing
in any fumes from the glue or work in a ventilated room.
• The use of barrier creams on hands or wearing
disposable gloves, and working in a well ventilated
area, is strongly recommended.
• Not suitable to children under 14 years of age.
Thank you for purchasing this Air-Graphics product which
forms part of a range of accessories, conversion sets,
decals & kits all to 1/72 Scale.
2
3
45
1
6
78
9
10 11
12
13
14 15
16
17 18
19 20
21
22
23
24
25
26 27
28
29
30
31
32
33
34 35