Air Products RT-3000-N User manual
RT-3000-N
Ionization Type, 4-Wire Duct Smoke Detector
RT-3000-P
Photoelectric Type, 4-Wire Duct Smoke Detector
INSTALLATION & MAINTENANCE INSTRUCTIONS
FOR RT-3000 SERIES DUCT SMOKE DETECTORS
You in Control
AND
AIR PRODUCTS
CONTROLS
RT-3000-N Ionization Type, 4-Wire DSD
RT-3000-P Photoelectric Type, 4-Wire DSD
For the correct installation of a duct
smoke unit, please refer to the NFPA 72 (National
Fire Alarm Code), NFPA 90A (Standard for Installation
of Air Conditioning and Ventilation Systems), NFPA
92A (Recommended Practice for Smoke Control
Systems.), NFPA 5000 (Building Construction and
Safety Code), IMC (International Mechanical Code),
IFC (International Fire Code) and NEC (National
Electric Code).
INLET TUBE
HOLES FACE
AIR FLOW
DUCT WIDTH AIR FLOW DIRECTION
INSERT RED STOPPER
THIS END OF INLET TUBE
EXHAUST TUBE INSTALLED
DOWNSTREAM OF AIRFLOW
DO NOT INSERT RED STOPPER
NOTE: Mountings shown
are typical. Detectors can
be installed side, bottom
or top of duct as long as
proper tube operation and
flow/pressure performance
is maintained
Tube Support Hole only for Ducts Greater than 3 Feet Wide
1
1
1
111
1111
1111
1
2
12
20 20
12
20 20
12 12
1
1
11
16
18 18
16
18 18
16 16
1
1
22
1
2
1
15
20
2
20 2020 20
21 2121 21
222
1 1 1
15 15 15
20 20 20
NOTE:
55
55
55
55
55
either of
these ends
25 Corporate DriveAuburn Hills48326
This manual suits for next models
1
Table of contents
Other Air Products Smoke Alarm manuals
