Air Techniques Peri-Pro User manual

Peri-Pro®Intra-Oral Film
Duplicator/Daylight Loader
Operating Instructions

Page 1Air Techniques, Inc.
The Film Duplicator/Daylight Loader for All Peri-Pro Intra-oral Film Processors combines
the convenience of Daylight Loader lm processing with a Film Duplicator.
Your new Pert-Pro Intra-Oral Film Duplicator/Daylight Loader features include -
• Duplicates up to eight lms simultaneously
• Has an automatically timed exposure
• Does not require a darkroom
• Duplicates size 0, I or 2 intraoral radiographs onto size 2 duplicating lm.
Before using the Film Duplicator/Daylight Loader, be sure to read and understand these
instructions thoroughly. The Peri-Pro Instruction Manual should also be reviewed prior to
processing lm.
Film Duplicator/Daylight Loader is comprised of the following components:
DUPLICATING
GRID
DUPLICATOR
DOOR
RETAINER
PLATE
DAYLIGHT
LOADER
CUFFS
PRISM
INTRODUCTION

Air Techniques, Inc. Page 2
1. Place original developed radiographs and a sufcient number of duplicating lms
inside the Film Duplicator/Daylight Loader.
NOTE:
Some duplicate lms are individually wrapped and can be handled in room
light during this step. Some duplicating lms are not individually wrapped and
are m a common pouch.
2. Close view glass
3. Insert hands through cuffs and open Duplicator Door
SECTION 1: OPERATION
4. Separate Retainer Plate from Duplicator Door and lift the plate up to anchor it open.
This provides access to the Duplicating Grid

Page 3Air Techniques, Inc.
5. Remove the desired number of size 2 duplicating lms (up to a maximum of eight)
from their wrapping or from the packaging pouch and place each lm inside a
section of the grid with the lighter side of lm (emulsion) facing up.
NOTE:
The duplicating lm has a projecting pin dot on the emulsion side. Make sure
this projecting dot faces up.
6. On each duplicating lm place an original, size 0,1 or 2 radiograph. Orient the
original so that the concave side of the embossed dot aligns with and nests with
the pin dot projection of the duplicating lm.

Air Techniques, Inc. Page 4
8. After light source shuts off, open Duplicator Door and separate the Retainer Plate
from the Duplicating Grid.
9. Remove original lms from the Duplicating Grid and set aside within the Daylight
Loader.
10. Remove the duplicating lm from the Duplicating Grid and process through the Peri-
Pro in the usual manner.
7. Close Duplicator Door and push rmly with both hands to activate the light source.
CAUTION:
Both latches must close securely or lm image will blur.
11. The original radiographs may be removed from the Daylight Loader after the
duplicates have dropped into the Peri-Pro.