AIRINNOVATIONS CLEAN MIST MH-419 Instruction Manual

READ AND SAVE THESE INSTRUCTIONS
nished size 5.5” wide x 8.5” high
CLEAN MIST® TOP-FILL
ULTRASONIC HUMIDIFIER
Instruction Manual and Warranty Information

Contents
Safety Instructions ............................................................................................................. 1
Unpacking / Specications ............................................................................................... 2
Parts & Contents ............................................................................................................... 3
Filling The Water Tank ....................................................................................................... 4
Operating Instructions ....................................................................................................... 5
Weekly Cleaning & Care / Storage .................................................................................... 6
Troubleshooting ................................................................................................................. 7
Other Great Products ........................................................................................................ 8
Warranty ............................................................................................................................ 9
If you have a respiratory condition, please contact your physician prior to use.
FCC STATEMENT
Potential for Radio/Television interference
This device complies with Part 18 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.This product has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 18 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
The product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that the interference will not occur in a particular installation. If the product does cause harmful interference to
radio or television reception, which can be determined by turning the product on or o, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the product and the receiver.
• Connect the product into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Changes or modications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.

1
SAFETY INSTRUCTIONS
• This appliance has a polarized plug (one blade is wider than the other) as a safety
feature. If the plug does not t fully into the outlet, reverse the plug. If it still doesn’t
t, contact a qualied electrician. DO NOT attempt to defeat this safety feature.
• Before using the humidier, extend the cord and inspect for any signs of damage; DO
NOT use if the cord has been damaged.
• Keep cord away from heated surfaces and out of the way, where it cannot be
stepped on or tripped over.
• NEVER use in an environment where explosive gases are present.
• Place humidier on a stable level surface; DO NOT place on carpet, next to
heating vents, under direct sunlight, in high temperature areas, or near computers
and electronic equipment.
• DO NOT place the the humidier directly on wood furniture or other surfaces which
could get damaged by water.
• DO NOT direct the mist against a wall or home appliances.
• NEVER operate without water in the Tank; DO NOT use anything other than room
temperature tap or distilled water.
• DO NOT touch the water in the Base during operation.
• DO NOT expose or immerse the Base in water when cleaning.
• DO NOT pour water into the base through the Air Outlet during cleaning and lling.
• NEVER block the Air Outlet or intake or cover the unit when it’s in operation
• DO NOT use any attachments not provided with the unit.
• Discontinue use if humidier makes loud noises or has a strange smell.
• DO NOT attempt to repair or adjust the unit; servicing must be performed by
professional or qualied personnel.
• Only operate when fully assembled; only use as intended and described in this manual.
• Keep out of reach of small children.
• Always insert plug securely into the power source.
• Unplug the unit and empty the Water Tank and Base before carrying/moving.
• Only unplug when the humidier is turned o; ensure hands are dry.
• Always turn o the unit before removing, emptying or lling the Water Tank.
• Perform regular maintenance of the Ultrasonic Nebulizer; NEVER scrape Nebulizer with
a hard or sharp object.
• Dry the unit completely before storage; store in a cool, dry place.
• Do not drop, hit or otherwise subject this product to excessive shock.
READ AND SAVE THESE INSTRUCTIONS: Failure to follow
all the instructions may result in electrical shock.
WARNING
CAUTION

No More Dry Air
Thank you for choosing the Air Innovations® – Clean Mist® Top-Fill Ultrasonic Humidier
and congratulations on taking this important step in improving the quality of air in your
home or oce.
This Humidier uses Ultrasonic Technology to create humidity instantaneously, while
working silently to erase the discomforts of dry air.
Specications
Unpacking
*Follow directions to ll and operate the humidier.
2
Remove the humidier from the box.
Remove all external and internal packing
(refer to page 4.).
MH-419 110-120V~60Hz 4.5L / 1.2G 3.86 Lbs.
8”W x 7.67”D x
12”H

1. Water Tank
2. LED Light
3. Water Reservoir / Base
4. Power/Mist Control Knob
5. Water Tank Cover
6. Mist Outlet
7. Mesh Filter
8. Water Window
9. Air Inlet
10. Ultrasonic Nebulizer
11. Water Sensor Float
12. Water Sensor
Top View
Water Tank
Water Reservoir / Base
3
Parts & Contents
9
11
4
1
2
3
5
6
7
12
8
10

Remove the Water Tank from the Base.
For rst use:
Remove the foam insert located above
the Water Sensor Float.
Fill the Tank with clean, cool water. Do not
allow water to enter the Mist Outlet.
Replace the Tank with the Mist Outlet
facing forward.
12
34
Filling The Water Tank
About White Dust
Use of high mineral content water may cause a white mineral residue to accumulate
on surfaces in the room near the humidier. The mineral residue is commonly called
“white dust” and is caused by minerals suspended in the water. The higher the
mineral content (or, the harder your water is), the greater the potential for white dust.
The dust is not caused by a defect in the humidier. To reduce white dust we
recommend using ltered or distilled water.
WARNING: If you have hard tap water, we recommend using ONLY ltered or distilled water.
4

55
Operating Instructions
ON / OFF
Plug into a standard (120V AC) electrical outlet. Turn the Mist Control Knob clockwise
to turn the unit ON. The LED Light will illuminate blue. To turn OFF, turn the Mist Control
Knob counterclockwise until you hear a click and the light turns o.
MIST OUTPUT
The unit will turn ON with the lowest mist setting. Turn the Mist Control Knob clockwise
to increase the mist output and turn the Mist Control Knob counterclockwise to decrease.
LOW WATER
When the tank is out of water the LED Light will turn from blue to red and the automatic
safety shut-o will turn the Ultrasonic Nebulizer OFF. You may hear the fan for a few
seconds, this is normal.

6
Weekly Cleaning & Care
Storage
1. Follow all cleaning instructions prior to storage.
2. Dry all parts, including the inside of the Water Tank and the Water Reservoir.
3. Preferably store in its original box, in a dry place away from high temperatures.
We recommend thoroughly cleaning the humidier at least once a week.
To Clean the Tank
Remove the Water Tank and empty the water. Clean and wipe the Tank with a soft damp
cloth. If necessary a mild cleaning solution may be used. The Mesh Filter Screws
onto the base of the Tank. To clean, remove the lter, rinse with water and replace.
To Clean the Base
Empty the water from the Base, pouring away from the Air Inlet. Wipe with a soft cloth.
To remove any scale or build-up in the Base or on the Ultrasonic Nebulizer, pour
a 50/50 mixture of vinegar and lukewarm water onto the surface, then soak for
ve minutes. Clean with the provided brush and rinse. Note: Never submerge the base
in water or any liquid.
To Clean the Surface
Clean the surface of the humidier with a clean, soft, damp cloth as often as needed.

Troubleshooting
7
Problem Solution
Weak or no mist output. The water in the unit is too cold: Replace with cool but not
cold water or set output to High and wait 10-15 minutes.
The surface of the Ultrasonic Nebulizer is dirty: Clean
Ultrasonic Nebulizer. (see pg. 6)
Ultrasonic Nebulizer is not working: See Warranty.
White dust is forming on
nearby furniture.
Hard tap water may deposit a certain amount of dust.
To reduce white dust, we recommend ltered or distilled water.
Water is leaking. Humidier is not on a level surface: Place on level surface.
Condensation is forming
around humidier or
windows.
Mist output level is too high for room size: Decrease the mist
output.
Missing parts. Call us toll free at: 844-600-1370, Monday thru Friday
8:30am to 5pm EST.
Please reference model: MH-419

8
Try These Other Great
Products For Your Life!
Available at: www.ForLifeProducts.com, www.Air-Innovations.com, www.Pursfection.com, www.RejuvenateProducts.com

1-YEAR WARRANTY - MH-419
Air Innovations® Clean Mist® Top-Fill Ultrasonic Humidifer comes with a 1-year manu-
facturer’s warranty. If this unit should become defective within 1-year from the date of
purchase, or if you have any questions or comments or regarding replacements for any
of our products, please contact us directly at:
Call us toll free at: 844-600-1370
Monday thru Friday 8:30 AM to 5:00 PM EST.
Visit us on the web at: www.Air-Innovations.com
e-mail us: [e-mail]
Or write us:
Great Innovations, LLC
Att: Quality Assurance Dept.
2301 SW 145th Ave.
Miramar, FL. 33027 USA
Please ll out the warranty card and
mail back to the above address.
Or, register your warranty online today.
Simply go to:
www.Air-Innovations.com
NAME
ADDRESS
CITY
STATE ZIP
TELEPHONE
E-MAIL
DATE OF PURCHASE
PLACE OF PURCHASE
THIS UNIT COMES WITH A 1-YEAR WARRANTY SUBJECT TO THE FOLLOWING CONDITIONS:
In the rst year, all repairs will be performed free of charge or the unit will be replaced. This warranty
is not transferable, it is valid only for the original purchaser. This warranty will be voided if the unit is
subjected to unauthorized repair or impact damage. If you have any questions please call toll free:
844-600-1370. This warranty gives you specic legal rights, and you may also have other rights
which vary from state to state.
Please check here if you would not like to receive any solicitations from our company
!
9

Air Innovations® ©2020 Great Innovations, LLC. All Rights Reserved. US & International Patents Pending. Printed in China.