Airlink101 AWLL5166HP User manual

Wireless N 150 High Power USB Adapter
Model #: AWLL5166HP
Quick Installation Guide for
MAC OS X
Rev. 1.0

2
NOTE: DO NOT PLUG IN THE USB ADAPTER UNTIL THE DRIVER IS INSTALLED!
1. Install Driver and Utility
This section provides instructions on how to install the Wireless N 150 High Power USB
Adapter. The driver is installed along with the utility.
Step 1 Insert the provided CD into the CD drive.
Step 2 Explore the CD content, go to MAC > 10.4, 10.5 or 10.6 (depends on your MAC
OS version). Double click on Installer.pkg to start installing the driver & utility.

3
Step 3 Introduction: The “Install Wireless N USB Adapter Driver” window will pop up.
Click Continue.
Step 4 Read Me: Read the instruction of installation. Click Continue to begin the
installation.

4
Step 5 License: Click Continue.
Step 6 Click Agree to install.

5
Step 7 Installation Type: click Install to perform a standard installation.
Step 8 Enter your password and click OK.

6
Step 9 Click Continue Installation.
Step 10 Install: Wait while the software is being installed.
Step 11 Summary: Click Restart to restart your computer.
Go to Chapter 2 after the computer is restarted.

7
2. Connect the Wireless USB Adapter
2.1 Enable the Wireless USB Adapter
This section describes how to enable your wireless USB adapter before you can connect
to a wireless network.
Step 1 After the computer is restarted, insert the Wireless USB Adapter into an available
USB port on your computer.
For 10.6 MAC users:
After the computer is restarted, you will see this notice popping up on your screen to
inform you to enable the wireless card.

8
Step 2 Go to System Preferences > Network.
You should see RTL8188S WLAN Adapter in the list, if not, please click “+” to add a new
network interface.

9
Step 3 Click on the Interface drop-down list and select RTL8188S WLAN Adapter and
click Create. Click Apply to save the settings.
Step 4 Click Apply to save the settings.

10
For 10.4/10.5 MAC users:
Step 2 Go to System Preferences > Network, select Network Port Configurations
from Show.
Step 3 Check the Ethernet Adaptor (Wireless N USB Adapter) and uncheck
AirPort. Click Apply Now.