airquee PLAYZONE AQ2711 User manual

Version 1.0 21/09/16
Page 1of 3
PLAYZONE
IMPORTANT
AS THE OWNER/OPERATOR IT IS YOUR RESPONSIBILITY TO WRITE AND CARRY OUT YOUR OWN RISK
ASSESSMENTS BEFORE ATTEMPTING TO USE THIS PRODUCT.
Site survey:
1. Carry out a survey of the area where the ‘Playzone’will be located, and check for
any overhead/underground cables. It’s important that this is carried out to avoid
ground anchors penetrating underground services, and the ‘Playzone’ coming into
contact with overhead cables when inflated.

Page 2of 3
2. You should provide an adequate power supply to the fan, this should adhere to
your local power regulations.
Included with your ‘Playzone’:
To best ensure the protection of accessories for your product (in this case the 4xballs and
the safety mats) they will be wrapped inside your inflatable, inside the fan box, or wrapped
separately.
The inflatable in its bag
Anchor Pegs
1.5HP Fan-check the
fan
4x Ballpond Balls
Colors may vary
Land Operation Manual
Slide Safety Mats
Extra equipment needed in addition what is supplied with your inflatable:
Suitable 240v Power Supply to operate the fan.
Extra equipment you could consider for your new inflatable:
Ground sheet to protect the underside of your inflatable
Sandbag covers to anchor your inflatable indoors.
Sack truck to move your inflatable safely
RCD to attach to you extension lead
Crash Mats
This inflatable can be set up and packed away by 1 person who has had proper manual
handling training and uses the correct equipment to move the inflatable.
x1

Page 3of 3
Set up:
1. This inflatable is intended to be used on soft floor and if you are inflating on a hard ground
we recommend protective matting to be used under the inflatable. In this case lay out mats
so that there are no gaps between them.
2. Unroll and lay out the ‘Playzone’ onto the mats making sure that every part of the
‘Playzone’ is contact with the mats, please observe how the ‘Playzone’ has been rolled as
reverse will need to be done after Take Down.
3. Position the fan and attach to the inlet tube and fasten, make sure that other inlet tubes are
tied off.
4. Children should not be allowed to come in contact with the fan so this area should be
cordoned off.
5. Switch on the fan and inflate.
Important:
The slide has safety mats to cushion the landing. When you set up your unit it is
imperative to position the safety mats on both ends of the slide –see image below:
The ball pond also has a safety mat –please note the mat needs to be in its place at
all time. When in use the ball pond needs to be filled with balls.