airquee Inflatable Yacht Operating instructions

Version 1.0 15/05/17
Page 1of 4
Inflatable Yacht
IMPORTANT
AS OWNER/OPERATOR IT IS YOUR RESPONSIBILITY TO WRITE AND CARRY OUT
YOUR OWN RISK ASSESSMENT BEFORE ATTEMPTING TO USE THIS PRODUCT.
Site survey:
1. Carry out a survey of the area where the Inflatable Yacht will be located, and check
for any overhead/underground cables. It’s important that this is carried out to avoid
ground anchors penetrating underground services, and the Inflatable Yacht coming
into contact with overhead cables when inflated.
2. You should provide an adequate power supply to the fan, this should adhere to
your local power regulations.
3. Check wind speed: The industry recommends a maximum wind speed of Force 5
on the Beaufort scale of 28 - 38 kmph (19-24 mph). Force 5 is a fresh breeze when
small trees in leaf begin to sway.

Page 2of 4
3X
Included with your Inflatable Yacht:
Extra equipment needed in addition what is supplied with your inflatable:
•Suitable 240v Power Supply to operate the fan
Extra equipment you could consider for your new inflatable:
•Ground sheet to protect the underside of your inflatable
•Sandbag covers to anchor your inflatable indoors
•Sack truck to move your inflatable safely
•RCD to attach to your extension lead
•Crash Mats
This inflatable can be set up and packed away by 3 persons who have
had proper manual handling training and use the correct equipment to
move the inflatable.
Set up:
1. After unfolding the 2 bottom parts of the unit, please connect the Velcro flaps in
the order shown on the pictures below.
- Connect the red flap of the bed.
The inflatable
in its bag Anchor Pegs Land Operation
Manual Repair Kit

Page 3of 4
- Place the blue soft Velcro flaps
between the red Velcros.
- Lower the red hard Velcro flap on the
blue one.
- Now connect the blue Velcro
flap on both walls of the unit.
2. Now you must place the top part of the unit on the already connected bottom two part.
When doing so you must look for the FRONT OF THE UNIT (with the inscription
www.royalyachtbritannia.co.uk) and place the top according to the below picture.

Page 4of 4
IMPORTANT
Please add the bunting to the unit AFTER unfolding, but BEFORE inflating the unit.
Please take OFF the bunting AFTER deflating, but BEFORE folding and packing the unit
away. If not, the bunting cable can cause harm to the unit while being folded.
Please notice on the picture below the dimensions of the bunting expressed in
centimeters.
Please attach the correct bunting to the correct Velcro connection points according to the
picture.
- Simply insert the end of the bunting between the
Velcro flaps located on the chimneys and the
unit.
All the pictures and drawings are for illustration purposes only.
ENJOY AND HAVE FUN!
THE FRONT OF THE UNIT