airquee Kick 'N' Stick Single Sided Upright Operating instructions

Version 1.3 31/05/17
Page 1of 4
Kick ‘N’ Stick Single Sided Upright
IMPORTANT
AS OWNER/OPERATOR IT IS YOUR RESPONSIBILITY TO WRITE AND CARRY OUT
YOUR OWN RISK ASSESSMENT BEFORE ATTEMPTING TO USE THIS PRODUCT.
Site survey:
1. Carry out a survey of the area where the ‘Kick ‘N’ Stick Single Sided Upright’will
be located, and check for any overhead/underground cables. It’s important that this
is carried out to avoid ground anchors penetrating underground services, and the
‘Kick ‘N’ Stick Single Sided Upright’coming into contact with overhead cables when
inflated.
2. You should provide an adequate power supply to the fan, this should adhere to
your local power regulations.
3. Check wind speed:The industry recommends a maximum wind speed of Force 5
on the Beaufort scale of 28 - 38 kmph (19-24 mph). Force 5 is a fresh breeze when
small trees in leaf begin to sway.

Page 2of 4
2X
3X
Included with your Kick ‘N’ Stick Single Sided Upright:
Extra equipment needed in addition what is supplied with your inflatable:
•Suitable 240v Power Supply to operate the fan
Extra equipment you could consider for your new inflatable:
•Ground sheet to protect the underside of your inflatable
•Sandbag covers to anchor your inflatable indoors
•Sack truck to move your inflatable safely
•RCD to attach to your extension lead
•Crash Mats
This inflatable can be set up and packed away by 2 persons who have
had proper manual handling training and use the correct equipment to
move the inflatable.
The unit comes with an Airquee Velcro Target Sheet.
The inflatable in
its bag
Anchor Pegs
Velcro Footballs
Collecting Stick
Handpump
Land Operation
Manual Repair Kit Ropes

Page 3of 4
When ordering, you may choose the Dartboard Target Velcro sheet too:
Set up:
- Unfold and flatten the inflatable on its Velcro side upwards.
- Install the desired Velcro sheet on the uninflated game.
Please note the Penalty Shoot Out Target Sheet isn’t compatible with this type of Kick ‘N’ Stick.
IMPORTANT:
Please do not over inflate the balls to avoid damage on the Velcro cover!
Players must be minimum 15 metres away from the target, otherwise the ball will
not stick.
Assembly of the Collecting Stick:
Parts of the collecting stick:
1. Attach the Head part to the Middle part by pressing
down the two metal buttons and inserting it until
they pop out in the two holes of the Middle part.
Head part
Middle part
End part

Page 4of 4
2. Connect the Middle part with the End part by
twisting the black handle.
3. Connect the Middle part to the End part by pressing
the two metal buttons and inserting it until they pop
into the two holes of the End part.
All the pictures and drawings are for illustration purposes only.
ENJOY AND HAVE FUN!