airquee DISCO READY FEATURE Operating instructions

Page 1of 3
“DISCO READY” FEATURE
(light pocket and speaker holding platform)
Your unit has a “Disco Ready” feature. This means a Light Pocket on the ceiling, a Speaker
Holding Platform with a scrim window and an Installed Electrical Wiring.
IMPORTANT: THE ELECTRICAL ITEMS THAT YOU CHOOSE TO USE IN YOUR
INFLATABLE MUST MEET THE SAFETY STANDARDS OF THE COUNTRY YOU
ARE OPERATING IN. YOU MUST ENSURE ALL ITEMS ARE CE MARKED.
All cables and electrical equipment must be tested in accordance with the regulations of your
country.
In accordance with British HSE guidelines, all 240v equipment should be protected with an
RCD having a maximum trip current of at least 30 mA.
SPEAKER HOLDING
PLATFORM WITH RAIN COVER
CLEAR PVC
LIGHT POCKET
ELECTRIC CABLE OUTLET
ROUND SCRIM WINDOW

Page 2of 3
Lights:
The disco lights that you buy will be installed after the unit is unfolded, but in an uninflated state.
Always read the instruction manual you receive with your lights before installing it into the unit.
The light holding chamber can be reached through a zip on top of the unit.
- Search for the zip covered with a Velcro flap
on the top of the unit.
- Unzip both zips (exterior and interior) and
insert the light in the clear PVC pocket.
- Please make sure to close both zips. This way
the cable won’t be able to unplug itself when
the unit is getting inflated.
Speaker:
The disco speaker will be installed in the unit, after the unit is totally inflated. It should be placed as
seen in the figure below and secured with the straps.
TIGHTEN BOTH WEBBING
CAM BUCKLE STRAPS
RAIN COVER

Page 3of 3
IMPORTANT INFORMATION
- High Noise Hazard: Extended exposure to very high-volume sound can cause serious
damage to hearing. Please exercise caution when setting the volume and remember that
inside the unit the sound is enclosed and much louder!
- The speaker, lights and electrical wiring used within the unit are not water proof or water
resistant.
- When inflated, the air pressure will prevent ingress of water into the unit but it cannot be
guaranteed to stop all water reaching the electrical parts. Therefore, we do not recommend
operating the unit in the rain. If you suspect water has entered any of the electrical
components they should not be used until completely dry and tested. We recommend taking
professional advice where necessary.
- When the unit is deflated the lights and speaker should be removed as soon as possible
and stored safely. The wiring harness should be left in place and the unit should be rolled to
prevent water lying on the unit and seeping into the sockets.
- The disco speaker will be unplugged and taken out from the unit before deflating the unit.
- The disco light will be taken out after the unit is deflated.
- Please only use a light with a low heat output to not to melt/damage the clear pvc pocket.
- Check the cable and the sockets regularly (before and after every use) for any damages.
- In case of a short circuit the materials used for the unit are flame retardant, thus preventing
the spread of flames.
- The lights and speakers to be only used with an RCD.
Airquee reserves the right to change the content of this manual without a prior notice to the customer.
All the pictures and drawings contained in this manual are for illustration purposes only.
This additional manual to be sent only for units with Disco Ready feature. Version 1.0 24/04/2018