AirTight 60403 User manual

12V LED Digital Tire Inflator
OPERATOR’S MANUAL
Model No. 60403
Your tire inflator has been engineered and manufactured for dependability,
ease of operation, and operator safety. When properly cared for, it will give
you years of trouble-free performance.
WARNING
Please read and save these instructions. Read carefully before attempting
to assemble, install, operate or maintain the product described. Protect
yourself and others by observing all safety information. Failure to comply
with instructions could result in personal injury and/or property damage!
Retain this manual for future reference.
For assistance with this product call 800-426-1262 between 7 a.m. and 4 p.m. Pacific time.

WARNING Read and understand all
instructions before use. Failure to follow
instructions can result in personal injury
and/or property damage. Save these
instructions for future reference.
WARNING
•KEEP OUT OF THE REACH OF
CHILDREN. The inflator is not a toy and
is not intended for use by children.
•USE12VOLTDCpoweronly.Make
surethatyourvehicle’s12Voltpower
outlet is free of any ash residue or debris.
Adirty12Voltpoweroutletcancausethe
inflator and power cord to overheat.
Overheating can cause damage to your
inflator/vehicle and could cause bodily
harm or injury.
•Forusewithany12VDCpoweroutlet
rated15Ampsorhigher.DoNOTuse
with older 8 Amp cigarette lighter
receptacles.
•Thisinflatorisdesignedtoinflatecar
tires,biketires,ATVtires,sports
equipment, air mattresses, beach toys
and other inflatables. DO NOT USE FOR
ANY PURPOSE OTHER THAN
INFLATING.BODILYHARMOR
PERSONAL INJURY CAN OCCUR.
•NEVERexceedthemanufacturer’s
recommended pressure for any inflatable
object.DONOTOVER-INFLATE
OBJECTS. Over inflation can cause
personal injury and/or property damage.
CAUTION
•HOT-Donotholdinhandwhile
operating. Place compressor on ground
during use.
•DONOTruncompressorformorethan
10minutescontinuously.
•ALLOWTHECOMPRESSORTO
COOLATLEAST10MINUTESAFTER
EACH10MINUTESOFCONTINUOUS
USE.
•NEVERuseintrafficorotherunsafe
areas.
•NEVERleavetheinflatorrunning
unattended.
•DONOTcarrytheinflatorbytheair
hose or power cord as damage may
occur.
•Disconnectpowerwhennotinuse.
•Donotoperateinflatornearflammable
liquidsoringaseousorexplosive
atmospheres.Internalsparksmayignite
fumes.
•Donotoperateorstoreyourinflatorina
damp or wet locations.
•Keepinflatordry,clean,andfreefrom
DANGER Danger indicates an
imminently hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING Warningindicatesa
potentially hazardous situation which, if
not avoided, could result in death or
serious injury.
CAUTION Caution indicates a
potentially hazardous situation which, if
notavoided,MAYresultinminoror
moderate injury.
NOTICE Notice indicates
important information, that if not followed,
may cause damage to equipment.
SAFETY GUIDELINES / DEFINITIONS
IMPORTANT SAFETY INFORMATION

1. Confirm that the power button on the
inflator is in the “OFF” (button up)
position.
2. To use the inflation accessories, snap
either piece into the universal adapter
andpushthelevertolockintoplace.The
inflation accessory will fit securely.
3.Plugpowercordinto12VDCpower
outlet.
WARNING Forusewithany12VDC
poweroutletrated15-Ampsorhigher.Do
NOTusewitholder8-Ampcigarette
lighter receptacles.
4. Insert the appropriate inflation
accessory into the inflatable object (tire,
football, raft, etc.).
5. Holdthe(+)or(-)buttonfor
approximately5secondsuntilthedisplay
flashes. Set the required pressure using
the(+)or(-)buttons,thenwait2-3
seconds. The display will show the
current pressure value to which the
object will be inflated.
6. Push the power button to the “on”
(button down) position for the inflator to
start.Whenthepressuregaugereaches
thepre-setvalue,theinflatorwill
automatically switch off and the display
willshow“OFF”.Press(M),or(+)or(-)to
restart the compressor after finishing the
inflation of one object.
FEATURES
oil and grease. Always use a clean cloth
whencleaning.Neverusebrakefluids,
gasoline,petroleum-basedproducts,or
any strong solvent to clean the inflator.
•Operatetheinflatoronlywiththe
attachments that are included.
•USESAFETYGLASSES.Alsouseface
ordustmaskifoperationisdusty.
•Yourvehicle’s12Voltbatterymustbe
fully charged to get the best performance
from your inflator. If your vehicle’s battery
isweak,theinflatorwillnotworkatits
maximumoutputlevel.
•Forbestresults,itisrecommendedthat
you operate your inflator with your
vehicle’s engine running.
WARNING:DONOTRUNVEHICLE
ENGINE INSIDE A CONFINED AREA
SUCH AS A GARAGE as bodily injury or
asphyxiationresultingindeathcanoccur.
ALWAYSALLOWFORPROPER
VENTILATION.
•Mostvehicle12Voltpoweroutletswill
operate with vehicle ignition off; however,
some vehicles require that the ignition be
turned on.
•THISINFLATORISNOTDESIGNED
TO FILL AIR TANKS OR AIR SHOCKS.
OPERATING INSTRUCTIONS
•Easytoreadilluminateddigitaldisplay
•Digitalpressuregaugelet’syousetthe
desired pressure with the press of a
button
•Long-lastingLEDlightfornightuse
switches between white, red and flashing
red SOS signal for added safety
•100PSIMaximumpressurecapacity.
•Inflationaccessoriesincluded
•25in.HoseLength.
•9.2Ft.Powercord.

NOTICE The ON/OFF button can be
used to override the preset pressure
value if required.
8. To operate lights, toggle switch from
the “OFF” position to either the “Light”,
“Flash” or “SOS” positions for desired
lighting.
9. Unplugthepowercordfrom12VDC
power outlet.
P.O.Box88259Tukwila,WA98138•©2011WilmarCorporation
Allrightsreserved•airTIGHT™isatrademarkofWilmarCorporation
TROUBLE SHOOTING
INFLATOR DOES NOT WORK WHEN
SWITCHED TO “ON”
•Powercordmaynotbepluggedin
completely.Checktheconnection.
•Checkvehiclepoweroutletandpower
plugterminalsfordirt.Useanon-
conductive probe, not fingers or metal, to
clean.
•Checktoseeifthepre-programmed
pressure is set to a lower PSI than your
tire currently is reading (i.e., the digital
gaugeissetto15psibutyourtireisat
2opsi;inthisscenario,theinflatorwill
not turn on) Refer to the digital gauge
operating instructions and set the PSI to
the correct tire pressure.
•Checkvehiclepoweroutletfuse,which
shouldbeaminimumof15Amps.
•Fusemayhaveblown.Checkfusein
power plug adaptor and replace if
necessary with one of the same
amperage.NEVERreplaceablownfuse
with a fuse having a higher rating.
UNIT IS RUNNING BUT TIRE IS NOT
INFLATING
•Checkthattheairhoseconnectoris
attached properly to the tire valve stem.
•Checkfortireleaksordamage,and
checkairhoseforbreaksandleaksat
fittings.
INFLATOR FEELS HOT OR RUNS
SLOWLY
•Unitmayhaveoverheated.Shuttheunit
offandallowtocoolfor20-25minutes.
•NEVERusethisinflatorformorethan
10minutescontinuously.
•Voltagemaybetoolow.Check
condition of vehicle battery.