AirTight 60397 User manual

120V AIR INFLATOR/DEFLATOR
OPERATOR’S MANUAL
Model No. 60397
IMPORTANT
1: Power supply needed is 120VAC 60Hz.
2: This pump is not designed for non-stop continuous use.
3: Extended operation over 10 minutes can overheat and damage the pump.
4: Keep the air pump out of the reach of children.
5: Do not obstruct the inflation/deflation port and keep them ventilated all the time.
6: T o reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.
7: Unplug from outlet when not in use and before cleaning or servicing.
WARNING
Please read and save these instructions. Read carefully before attempting to assemble, install,
operate or maintain the product described. Protect yourself and others by observing all safety
information. Failure to comply with instructions could result in personal injury and/or property
damage! Retain this manual for future reference.
For assistance with this product call 800-426-1262 between 7 a.m. and 4 p.m. Pacific time.
P.O. Box 88259 Tukwila, WA 98138 • © 2015 Wilmar Corporation
All rights reserved • airTIGHT™ is a trademark of Wilmar Corporation
1 YEAR LIMITED WARRANTY
AIR TIGHT® extends only the following warranties, and only to original retail purchasers.
These warranties give specific legal rights. Except where prohibited by local law, the law of
the State of Washington governs all warranties and all exclusions and limitations of warranties
and remedies. There may be other rights which vary from state to state.
AIR TIGHT® warrants the product to be free from defects in materials and workmanship
under normal use and service. A defective product may be returned for a free replacement
within 90 days from the date of purchase, provided that product is returned to place of
purchase immediately after discovery of defect. After 90 days and up to one year from
date of purchase, AIR TIGHT® will replace at no charge any parts which our examination
shall disclose to be defective and under warranty. These warranties shall be valid only
when a sales receipt showing the date of purchase accompanies the defective product or
defective part(s) being returned. For part(s) after 90 days, please remit your request,
postage prepaid to:
PERFORMANCE TOOL, P.O. Box 88259 Tukwila, WA 98138
These warranties exclude blades, bits, punches, dies, bulbs, fuses, hoses, and other
consumables which must be replaced under normal use and service. These warranties shall
not apply to any product or part which is used for a purpose for which it is not designed, or
which has been repaired or altered in any way so as to affect adversely its performance or
reliability, nor shall these warranties apply to any product or part which has been subject to
misuse, neglect, accident or wear and tear incident to normal use and service.
AIR TIGHT® does not authorize any other person to make any warranty or to assume any
liability in connection with its products.
Except for warranties of title and the limited express warranties set forth above, AIR
TIGHT® makes no express or implied warranties of any kind with respect to its products.
In particular, AIR TIGHT® makes no implied warranty of merchantability and no implied
warranty of fitness for any particular purpose, except that for goods purchased primarily
for personal, family or household use and not for commercial or business use, AIR
TIGHT® makes an implied warranty of merchantability (and, if otherwise applicable, an
implied warranty of fitness for a particular purpose), but only for the particular qualities or
characteristics, and for the duration, expressly warranted above. The laws on limitation of
implied warranties may differ from state to state, so the above limitations may not apply in
all cases.
AIR TIGHT® shall not be liable for consequential, incidental or special damages resulting
from or in any manner related to any product, or to the design, use, or any inability to use
the product. The sole and exclusive remedy for a defective product or part shall be the
repair, or replacement thereof as provided above. The laws on limitation of remedies or on
consequential, incidental or special damages may vary from state to state, so the above
limitations may not apply in all cases.

WARNING -
To reduce the risk contact qualified electrician to repair or replace the damaged cord immediately.
Carefully follow the instructions on inflatable item when inflating.
Never exceed recommended pressure, otherwise serious injury might be caused by the
bursting of the item.
Never leave pump unattended while the pump is in use.
Do not keep/use the pump in a wet condition.
Never allow sand, small rocks, etc. to be sucked into inflation/deflation port when using this pump.
Never look inside or point the inflation port towards your eyes when the pump is on.
Stop at least for 5 minutes after 10 minutes of continuous use.
To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control
devices.
Never attempt to put your hands or fingers into the inflation/deflation port at any time.
Don’t disconnect any electrical equipment with wet hands.
Don’t move the pump with aid of the supply cord.
If the pump is not in use, please turn it off.
Don’t use if the pump is damaged, especially the supply cord and the case.
Don’t immerse the pump in liquid.
A periodically maintenance of the pump is necessary.
Do not put the pump down near hot surfaces ex. hotplate, oven etc. because the material can melt.
The pump should not be impelled by covering the ventilation openings with items such as
newspapers, table cloths, curtains, etc.
To reduce the risk of electric shock, do not connect unit of the extension cord to electric supply; and
contact a qualified electrician to replace the damaged cord immediately.
Carefully follow the instructions on inflatable item when inflating. Never exceed recommended
pressure, otherwise serious injury may occur by the bursting of the item.
Never leave pump un-attended while in use.
Do not keep/use the pump in a wet condition.
Never allow sand, small rocks, etc. to be sucked into the inflation/deflation port when using the pump.
Never look inside or point the inflation/deflation port towards your eyes when the pump is on.
Never attempt to put your hand or fingers into the inflation/deflation port at any time.
Save the original packing box for storage purpose.
Let the air pump cool down for at least 30 minutes before storage.
Store the air pump on a cool/dry place. Keep out of reach of direct sunlight and chemical substances.
The motor of this air pump is protected by a thermal overload protection device. This device detects
any over-heat condition and will turn off the motor automatically; the motor will be turned back on
automatically upon cooling down.
Use only damp cloth soaked in mild soap/detergent and water to clean the outer surfaces of the
pump. Do not use any kind of chemical or solvent. Always unplug the air pump and stow the cord
during cleaning. Do not twist the supply cord while in use.
This air pump does not contain any user serviceable part, any other servicing is to be performed by
an authorized service representative.
Read ALL instructions before using
DANGER - To reduce the risk of electric shock: Always unplug from the electrical outlet before
cleaning. Do not expose to rain or use near water, store indoors.
WARNING-To reduce the risk of burns, fire, electric shock, or injury to persons: Do not use this
with any solid-state speed control device. Using the built in air pump for a long time can
overheat and damage the pump, do not operate the air pump for more than 10 minutes.
This air pump has been specially designed to inflate/deflate air beds and other novelty
inflatables only. Do not attempt to alter or modify the air pump in any way to be used to other
large inflatables, doing so will void the warranty.
Carefully follow instruction of articles to be inflated. Never exceed recommended pressure.
Over inflation may burst the item and can cause serious injury. Never leave air pump
unattended during using. Do not use in wet conditions, or where the pump is exposed to
moisture. Never look into or point the inflation opening with your eyes while the air pump is
operating. Do not attempt to put hand or fingers into the inflation or deflation port at any time.
Unplug from outlet before putting on or taking off parts. Keep this air pump out of the reach of
children. Close supervision is necessary when this product is used by, or near children, or
persons with special needs. Use this product only for its intended use as described in these
instructions. Do not use any other attachments not recommended by the manufacturer.
Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has
been dropped or damaged, or exposed to water. Keep the cord away from heated surfaces.
Never operate with the air openings blocked. Keep the air openings free of lint, hair, and other
foreign material. Never drop or insert any object into the air inlet or discharge port.
Do not use outdoors due to moisture potential, dry indoor household use only.
Do not operate where aerosol (spray) products are being used or where oxygen is being
administered. To disconnect, turn all controls to the off position, then remove plug from outlet.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Do not route cord under furniture or appliances, Arrange cord away from traffic
areas and where it will not be tripped over.
In a double-insulated product, two systems of insulation are provided instead of
grounding. No grounding means is provided on a double-insulated product, nor
should a means for grounding be added to the product. Servicing of a double-insulated product
requires extreme care and knowledge of the system, and should be done only by qualified
personnel. Replacement parts for a double-insulated product must be identical to those parts in
the product.
Use only a 2-wire extension cord that has a 2-blade polarized plug, and a 2-slot receptacle that
accepts the plug on the product. Make sure your extension cord is not damaged. When using
an extension cord, be sure to use one heavy enough to carry the current your product draws.
Do not use extension cords longer than 50 ft. the extension should be rated at least 300V and
with size no smaller than 18 AWG, cord type shall be no lighter than SPT-2, such as SVT, HPN,
SJT are acceptable cords. Overheating, short circuit and fire damage will result from
inadequate wiring.
IMPORTANT SAFETY INSTRUCTIONS OPERATING INSTRUCTIONS
2 3
SERVICING OF A DOUBLE-INSULATED PRODUCT
CARE, STORAGE AND MAINTENANCE