Akuvox SR01 User manual

How to Configure SR01 Security Relay on
Akuvox Door Phones
Scenario
If you need a higher degree of access security and safety, you need an SR01
security relay. Generally, the lock is directly connected to the door phone relay, but it
cannot be very safe when someone walks up to the door and smashes up the door
phone and breaks into the door for burglary and so on. And here SR01 has a role to
play. Because SR01 is installed indoors and controls the door opening directly, no
one can open the door by smashing up the door phone installed outside. SR01 helps
increase access security in all applications.
Operation Instruction
SR01 can be connected to:
Door phone: R20, R28, R29, X915, X912, E16
Access control unit: A02
Before you configure the SR01, make sure that:
You have properly wired up SR01 between the door phone and the door strike.
You have wired the SR01 to the external 12V power supply if you want it to be
powered by the third-party power adaptor.
Operation Procedure
1. Go to Access Control > Relay >12V Power Output.
2. Select Security Relay A.
Updated on 20 Oct 2022
Note
You can refer to the SR01 wiring quick guide for the proper wiring.

3. On the same page, scroll up to Security Relay.
4. Select the Security Relay.
Select Security Relay A for the SR01 to be powered by the door phone.
The relay is connected to the door phone via Relay A.
Select Security Relay B for the SR01 to be powered by the third-party
power supply. The relay is connected to the door phone via RS485.
5. Set the security relay.
Set the relay trigger delay timing (ranging from 1-10 Sec.) For example, if you set
the delay time as 5 sec. then the relay will not be triggered until 5 seconds after
you press Unlock tab. The default is 0 meaning triggering relay right after you
press the unlock tab.
Set the relay hold delay timing (ranging from 1-10 Sec.) For example, if you set
the hold delay time as 5 Sec. then the relay will be delayed for 5 after the door is
Note
Skip the two steps above if the SR01 security sensor is powered by a
third-party power supply.

unlocked.
Give a name to the security relay if needed, then enable the security relay feature.
You can run the test if the connected SR01 works.
Previous
How to integrate Linkey Smartlock with E16 for Access Control
Next
How to Set Up Metaverse Feature for Intercom Call on S539