ALCO BASELINE AL-63329 User manual

INSTRUCTION MANUAL
HYDRAULIC WRIST DYNAMOMETER
AL-63329

About the Baseline® Wrist Dynamometer
Simply and accurately measures the strength of the wrist
muscles during flexion, extension, abduction and adduction and the
forearm muscles during supination and pronation.
The Baseline® wrist/forearm dynamometer features the time
proven hydraulic system used in the industry accepted
Baseline® and Jamar® hand dynamometers.
For hand held use, the dynamometer can accommodate the
Baseline® single-grip and dual-grip handle.
Maximum reading remains until the unit is reset.
The strength reading can be viewed as pounds or kilograms.
Comes with portable carrying case.
Made in USA with a 1-year manufacturers warrantee.
CE certified.
d
a
c
b
e
f
Baseline® wrist/forearm dynamometer
Includes door knob grip and case.
AL-63329
analog (dial) readout
Call
digital (LCD) readout
measurement accessories
Measurement accessories easily snap on and off.
AL-63833 [d] door knob grip [supination / pronation]
AL-63834 [a] shovel handle [supination / pronation]
AL-63835 [c] lever handle [abduction / adduction]
AL-63836 [b] rod/pipe grip [flexion / extension]
AL-63342A [e] single grip handle
AL-63342C [f] dual grip handle
AL-63838 table-mount bracket

USAGE
Snap appropriate grip into the wrist dynamometer body to secure unit for test.
hold unit either by grasping the dynamometer body, or using a single or dual grip
handle. Set max indicator to zero. Have patient twist grip with maximum force,
note reading. Reset to zero for next test.
CALIBRATION
The BASELINE® wrist dynamometer is a sealed unit and calibrated at the facto-
ry. However, if indicator needle is out of “zero-range” it may be reset. Remove
clear cover by turning counter clockwise. Adjustment pin located by 220Kg mark-
ing. Turn pin to reset to zero. If unit is leaking hydraulic fluid it should be returned
to factory for repair and recalibration.
WARRANTY
The BASELINE® Hydraulic Wrist Dynamometer is warranteed for 1 (one) full year
(parts and labor) from date of purchase. If unit needs repair contact your local
dealer.
ALCO Sales & Service Co.
6851 High Grove Blvd
Burr Ridge, IL 60527
U.S.A.
TEL: [phone]
FAX: [phone]
HOW TO INSTALL HANDLES Dual Grip Handle
Single Grip Handle
Single Grip Handle:
1. Remove screws “D” and “J”
2. Position single grip handle and apply 2 thumb screws to connect the handle to the
openings at “D” and “H”
Dual Grip Handle:
1. Remove screws “A” “D” E” and “H”
2. Position dual grip handle and apply 4 thumb screws to connect the handle to the
openings at “A” “D” “E” and “H”
A B C D
E F G H
underside of wrist
dynamometer
800-323-4282 • 630-655-1900 • www.alcosales.com
[email protected]