Design • Print • Trace 07/07/2011
There is a re alarm LED on top of the print-hea . It starts blinking when the level of
ink is too low in the reservoir, which means that the bottle of ink is empty. Replace it by
following the steps escribe in 3.1.Ink bottle replacement
After a configure number of prints, if the ink level is still low in the reservoir, the
controller stops the printing (to avoi efective printings). See the controller manual for
information on configuring the number of prints after the ink-low signal.
When the ink low is etecte , the print-hea sen s an alarm signal to the controller,
which can transfer it to an external evice such as a PLC. See controller manual for
etails.
2 Start Up
2.1 On line installation
2.1.1 Defining the position of the system
After unpacking the printer an checking that the contents correspon to your or er
an to the elivery note, the first operation will be to set the position of the print-hea
on the conveyor. The correct print-hea position can be etermine using Co ex an
its 3D capabilities (Fig. 7). Please refer to the Co ex manual for etails.
You must know that the system must be a juste so that the surfaces to be printe
on't touch the print-hea , an are at a maximum istance of 3mm (Fig. 8).
TC series print-hea s Operator Manual 3
Fig. 7: Co eX 3D view with a TC72
