
Press and hold
the alert button
until the light
turns blue.
You will hear a
message, then a
tone, before being
connected to the
Command Center.
The Command
Center will send
help unless you
inform them that
you’re testing.
For those with Fall Detection, your pendant
can automatically send an alert if it senses a
fall, based on speed, impact, and lack of
movement. However, we do recommend
pressing your button whenever possible.
Test your system every week.
How to Wear Your Pendant
○
○
To Change From
Lanyard to Belt Clip
1. Turn the pendant so the call button faces
you. With your thumb, push the lanyard
attachment away from you until the lanyard
clicks off.
2. Place the horizontal piece of the clip on
top of the pendant so that the notches on
the pendant and the clip line up.
3. Press the clip into the pendant until it
slides securely into place.
Note: You can charge Zoey in its cradle with
the belt clip attached.
Important: Fully Charge
Before First Use
1. Plug in the charging cradle and place
Zoey into the cradle as shown. The light will
flash red every 5 seconds while charging
and becomes solid red when fully charged.
2. Typical charging time is 2-3 hours.
3. If the battery is low, the light will slowly
flash red when off the charging cradle. Also,
the device will state, “Battery low, please
charge” if you press the call button; it will
then place the call.
Note: Battery life will vary between 6 – 16
days, depending on the mode utilized. Only
charge as needed. If you have trouble
charging Zoey, wipe the connecting pins
with rubbing alcohol to clean debris.
Pendant Overview Set Up & Charging Testing & Calling for Help
Call button
Blue call
light / red
battery light
Microphones
Speaker