ALERTE Visor Light 88 User manual

05-27-09
®
ALERTE SYSTEMS INC
901 W 10th Street / P.O. Box 586 / Cassville, MO 65625
Local & International Numbers: U.S. and Canada Toll-Free Numbers:
Phone [phone] / Fax [phone] Phone [phone] / Fax [phone]
ALERTE

ALERTE

ALERTE

MODEL NO. 10.730
Visor Light 88
GENERAL INFORMATION:
INSTALLATION INSTRUCTIONS:
Two super bright LED arrays, 44 LED's per side. There are other array combinations to suit your jurisdiction or
ordinance requirements from RED, BLUE, AMBER, GREEN or WHITE LED's. Each array equipped with vertical
rows of white LEDs at their outer edges to provide the "halo" effect pioneered by ALERTE to enhance visibility.
Seven flash patterns to choose from:
1. 90 Single FPM Simultaneous
2. 90 Double FPM Simultaneous
3. 70 Quad FPM Simultaneous
4. 120 Alternating FPM
5. Automatic Alternating Variable Speed
6. Automatic Simultaneous Variable Speed
7. Automatic Random Select
To change flash pattern, press the momentary switch (Located on the lighter plug adapter). Each time the
momentary switch is pressed, the flash pattern will change.
Position the "Visor Light" on the visor, normally on the passenger side with the lenses facing downward when the
visor is in the up position.
Fasten the straps over the visor and position the "Visor Light" with its bottom edge even with the lower edge of the
visor. Tighten the straps to snug the "Visor Light" against the visor.
Clean the cable clip location on the windshield column and the dash with 409®, Fantastic®, or the equivalent prior to
affixing the clips. This procedure is particularly important if a silicone-based protectant such as Armor All® has been
used on these surfaces. Failure to adequately clean the clip mounting locations may prevent the adhesive on the
clips from securing a sound, long-lasting grip.
Place the cable in the clips. Open the clips only as much as necessary to insert the cable.
To operate, flip the visor down, insert the cable plug into the cigarette lighter socket and switch on.
NOTE: If the "Visor Light" is to be permanently wired, please specify at the time of the order, so when manufacturing
your light we can adjust the location of the switch. The current switch is located on the cigarette adapter.

05-27-09
LIMITED WARRANTY
ALERTE warrants each new product (except bulbs, strobe power supplies and strobe tubes) to be free from defects in
material and workmanship for a period of two years from the date of purchase. During this warranty period, the obligation
of ALERTE is limited to repairing or replacing, as ALERTE may elect, any part or parts, which after examination by
ALERTE are determined to be defective, when they are delivered pre-paid. This limited warranty does not cover travel
expense, the cost of specialized equipment for gaining access to the product, or labor charges for the removal and
re-installation of the product.
ALERTE shall not be liable for incidental or consequential damages, including but not limited to: loss of use of vehicle,
rental of substitute vehicle, loss of time, loss of work, inconvenience, transportation expenses, telephone, lodging, loss of
revenue, loss of and/ or damage to personal property for or arising out of breach of any express or implied warranty of its
products.
Use of lamp or other electrical load of wattage higher than installed or recommended by the factory, or use of inappropriate
or inadequate wiring or circuit protection causes this limited warranty to become void. ALERTE will in no way be liable for
any loss of profits or any indirect or consequential damages arising out of any such defect in material and workmanship
whether loss is due to negligence or breach of warranty. This limited warranty does not apply to shipping damage,
accident, alteration, tampering, misuse or abuse and unauthorized service.
This limited warranty is expressly in lieu of all other express or implied warranties, including the implied warranty of
merchant ability and the implied warranty of fitness for a particular purpose, and of all other obligation or liabilities on the
part of ALERTE. There are no warranties, unless expressed in authorized ALERTE literature, which extend beyond the
description of the face hereof. No dealer, distributor, employee, or representative of the company is authorized to change
this warranty in any way or to grant any other warranty.
PRODUCT RETURNS
If a product must be returned, contact our factory by calling 1-800-728-1536 to obtain a Return Authorization Number (RA)
before you ship the product. Write the RA number clearly on the package and return it to ALERTE Systems International,
Ltd., 901 West 10th Street, P.O. Box 586, Cassville, MO 65625. A packing slip should be included with all shipments listing
the sender's name, address, daytime phone number and description of defect. Your product will be put in first-class
operating condition or replaced with a new part, and returned pre-paid.
ALERTE

ALERTE

90.3281 Cig Ltr Plug
W/on/off & Mode switch
95.5007.R00
Random Flasher
PCB
106.157 5/ 16"
Grommet
90.6485 Retainer clip (4)
90.4590SS
Screws (4)
106.003 Lens (2)
90.6440 VL Cover
90.6441 VL Base
104.110 Lens
Screws (4)
ALERTE

109.009 20"
Velcro Straps