Alfa Network AIP-W525H V2 User manual

Presented by
Peter Spani
www.PcXpert.org
You can use, distribute, print this document, but do not modify it or put your
signature!
Before you begin, read the entire document.
Alfa AIP-W525H_V2 Router mode setup
Connect the AIP-W525H to a power source; connect a network cable to one of the LAN
ports and the other end to your Computer
Open any internet page and type 192.168.2.1 then press « Enter »
The page you should see, now just follow the images for setup

The Router will Reboot to finalize setup.
Now connect the AIPW525H to your Modem, or to the existing Router.

Connect a network cable to the WAN port of the AIP-W525H
If you have a modem, simply connect the other end into the modem’s jack.
If you have an existing Router, connect the other end to a LAN port of that
one.
You'll be on the internet in a few seconds.
You can also connect to the new wireless network created previously,
named Wifi_Alfa in this example.
Setup is done!
PS.
If you use the AIP-W525H on an existing router, it would be useful to know
the IP address of that Router, but not absolutely necessary, we use
192.168.3.1 here, which is not used by manufacturers as Router address,
(Important: third number must be different from main Router’s ip, egg:
main router 192.168.1.1 and second Router 192.168.2.1 .
To know the current address of your existing router, use the CMD
command:
[under Windows7 = Start / Search, type cmd]
[Windows XP = Start / Run, type cmd]
in the new window, type ipconfig and press the Enter key, the default
gateway is the address of your
Router.
Important note:
This setup Guide is free to use or give away, but do not modify it!
If you buy Alfa products from us they come pre-configured for your needs
with 100% FREE support.
If you buy the product else were, we still can help you but charges are
applied.

If you don’t agree to pay for help, please do not ask us, contact your sales
person or find information on internet.
Peter Spani
www.PcXpert.org