
www.allgood.co.uk Modric Washroom O&M Manual - 3
Hand dryers
The hand dryer MUST be isolated from
the power supply during installation or
maintenance.
• When cleaning the
stainless steel hand dryer
fascia, check for dirt and
grease and wipe clean as
directed in the ‘Care of
finishes’ section.
• Remove dust, fluff and any
other build up of foreign
matter from the inlet and
outlet grillle areas (Fig.7).
• Clean and check the sensor
area is clear of obstruction,
removing any obstructing
matter if required.
• If there is movement in
the hand dryer unit on the
wall check that the fixings
are tight. If the hand dyer
becomes loose, please tighten
the relevant fixings (Fig.8).
• If after completion of the
above checks the Modric
surface mounted hand dryer
is not working satifactory,
please contact Allgood
on 020 7387 9951
Fig.7 Fig.8
weekly checks
monthly checks