Allo RemoteControl SOMMER 4004 User manual

SOMMER 4004 – 4050
Remote-to-remote programming:
1. Open both remote controls by their sides and connect the two fobs
2. When the LEDs light up and then go off, press the button 1 on the new remote
control and hold it down
3. When The LED of your old remote control comes off, press and hold the
second button until the LED switches off.
4. Your new remote control is programmed!
INSTRUCTIONS
Visit our Website. www.alloremotecontrol.com

Receiver-based programming:
1. Disconnect your receiver. It is located next
to your motor.
2. Open the casing of your receiver
3. On the receiver circuit board (2), connect the
remote control as indicated in the diagram
above (1). The LED on the receiver lights up
(4).
4. Press the button you wish to program on
your new remote control (3). Keep it pressed
down. The LED light on the receiver turns
off. Release the button.
5. Wait 10 seconds
6. Your new remote control is programmed
Visit our Website: www.Alloremotecontol.com
Visit our Website: www.Alloremotecontrol.com
Visit our Website: www.Alloremotecontrol.com