Allo RemoteControl BERNER User manual

BERNER
Visit our website: www.Alloremotecontrol.com
INSTRUCTIONS
Assigning a button function:
The radio receiver has two channels for the control of two functions. Before
you can use the hand transmitter(s), you must assign the desired function in
the radio receiver to a button on the hand transmitter
Assigning a button function for channel 1:
1. Briefly press the P button (programming button) on the receiver. The LED
will begin to light up.
2. Press the desired button on the hand transmitter for at least three seconds
until the LED goes out.
3. Release the button. The receiver is ready to receive
Assigning a button function for channel 2
1. Briefly press the P button (programming button) on the receiver. The LED
will begin to light up.
2. Press the P button again. The LED will go out and then light up again.
3. Press the desired button on the hand transmitter for at least three seconds
until the LED goes out.
4. Release the button. The receiver is ready to receive.
Checking programming:
Press the programmed button on the transmitter
The command will be issued and the LED on the receiver will light up
Note: There must be a distance of at least 1 m between the transmitter and
the receiver. If the hand transmitter does not work, try to assign a button
function to the channel again
Visit our website: www.alloremotecontrol.com

Cancelling the programming procedure:
• If no programming is performed within 60 seconds after the P button is
pressed, the receiver's LED will go out.
• If you press the P button three times in a row, the receiver's LED will go
out and the programming procedure will be cancelled.