Allremote Wireless Technology 220S Series Manual

FCC INFORMATION
The Federal Communication Commission Radio Frequency Intererence Statement includes the
following paragraph:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
---------------------------------------------------------------------------------------------------------------
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
---------------------------------------------------------------------------------------------------------------
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment
1. This Transmitter must not be colocated or operating in conjunction with any other antenna
or transmitter.
2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
PACKING INCLUDED:
Model 220s LED Searchlight
Handheld Wireless Remote Controller
TX-SL014GO
Wired Joystick Controller
RX-SL008E
INSTALLATION
：
Unit：mm
Screw Hole:9.05



ME-03-0025 V.2019 MAR.
MotorizedRemoteControlSearchlight
Model 220S Series
Instruction Guide
FEATURES
：
LED lighting
360° Unlimited Rotation/135°Tilt
Programmable Handheld Wireless Remote Controller
UV Ray and Saltwater Resistant
Automatically return to home position when searchlight is turned off
*****Important Notice: If searchlight DC power is cut off (wires
disconnected from battery or power supply switched off), after
reconnected, make sure to turn on the searchlight, using wireless or wired
remote to make a full 360 rotation, in order to reset the home position
memory.
SPECIFICATION
：
Housing Color:
Black / White
Dimension： Unit：mm
LED module ：
LED chips X 10PCS / Watts: 50W
Current consumption: 13.5V 3.3A (MAX) / 28V 1.5A (MAX)
Color Temperature: 5,700~6,000K
Beam Pattern : Spot
Luminous intensity: 350,000 Candelas
Beam distance: 1,183M
Aluminum Housing as Heat Sink
Polycarbonate lens
Power: DC 12V ~ 24V (Multi-voltage)
Weight: 1.9Kgs / 4.2 lbs (Permanent mount)


OPERATION ：
HandheldWirelessRemote





1. Operation
Press on/off button to Switch on or off searchlight.
Operate directions of the light beam by pressing the direction buttons.
Up= Down= Right= Left=
2. Button Fn ：Dual speed (Fast / Slow speed switch)
HANDHELD WIRELESS REMOTE PROGRAMMING PROCESS
：
1. Switch off DC Power or disconnect from battery.
2. Make sure there is NO other transmitter operating at the same time.
3. Switch on DC Power, within 5 seconds press Remote up ▲and down
▼button once simultaneously.
4. Searchlight will flash to acknowledge the Remote, connection has
been made.
5. To program the second Remote (up to 4 remotes
may be used with the searchlight, programming a
fifth will replace the first), within five seconds after
the first Remote programmed, press the second
Remote up and down button or repeat step 1.
RADIO FREQUENCY
： 433.92MHz
Wireless Remote Battery: 23A*2pcs
Wireless Remote Operation Distance: 65M
DashMountWired/WirelessJoystick(Optional)
Wired Joystick= RX-SL008E
JoystickInstallation





